Recent content by 66Kooda

I was told they were for early A - lost all the information on the seller so I can't follow up with him.

Looking for some help, pictures, etc. Trying to get drivers side fenderwell header installed (Hedman Husler). I have plenty of space cut out - but the #1 cylinder tube comes out from the flange, turns 90 degrees, but doesn't run "parallel" with the the head long enough to clear the shock mount...

66 Barracuda - pulled 318 motor and trying to install new 408 (360) with Milodon high volume pump. I do not have enough clearance between the top side of the K member and the bottom of the block where the pan bolts on. Not sure why, being I've heard of guys using this same pan. I do have the...

They cam out of a 67 B body 8 3/4 housing. I’m not sure if they work in a 8 3/4 A body housing. You would have to verify the axle length.

B body

Sorry, forgot that. 4.5”

I have (2) factory axles for 8 3/4 with new green bearings installed. I ended up having Moser cut the housing down and purchased new ones instead. They are 30 spline and measure 28 9/16 from the back of the flange. New studs installed. $250 plus the ride.

It did suck, but they made it right. Cut and splined new ones this morning while I waited.

Ok guys I figured it out - Moser screwed up. The job sheet I sent was to cut 2” off each side of housing, supply new axles 2” shorter as well (if the old ones can’t be cut and resplined). They could not because of the taper. So somehow the new ones only net 1” shorter. So with one side in, the...

Need help: just installed a 8 3/4 housing i just had narrowed by Moser. Also bought new axles. I installed the new third member (4:10 spool). Left side axle went in just fine- right won’t go in all the way to seat bearing. It does engage enough to turn opposite side wheel and driveshaft. Seems...

Thx.

Thx.

Does anyone have a part# or link for the larger front leaf spring bushing for a 66 Barracuda? I'm doing a rear end swap (7 1/4 to 8 3/4) & spring relocation. I have a set of springs but noticed one of the front bushings are missing. I believe these might be whats called super stock springs but...

Looking for the biggest set I can get squeezed in my 66 Barracuda. Thought maybe someone has been down this road. I recently replaced my factory rear end with a 8.75 SG and I'm wanting as much rubber as I can get. From what I can tell by measuring, it looks like I can get a Hoosier 28x11.5 in...