do you still need spacers? I have many left over from big block builds and if my memory is correct, the rocker shaft of a 273 is the same diameter. Most are from Hughes engines and should align your rocker tip better than the oem spacers.
Get rid of the Comp camshaft!You are better off to install a purple shaft cam from Mopar Performance. I made the mistake of using a Comp cam xe274 in my big block. I spent nearly $900 CDN for a set of Hughes rockers,shafts and hardware. ($550 USD for parts) and the rest was shipping...
put the engine and trans into the car together. Bolt the transmission to the crossmember first and then check that the rear of the oil pump has at least 1/8" clearance.(round part of the pump fits in the space you created by cutting the K frame). When I put 451 in, I had to elongate the trans...
I have the same setup on my big block Dart. Not sure why you have a spring on the transmission lever. The lever should return to the "normal position" from internal pressure when the carb. is at idle. If the lever doesn't offer resistance when you push it towards the rear of the car, you need to...
I have a pair of these seals. Right and left side,plus the 2 little pieces that go under the chrome trim at the top of the wing window. Very good condition. Can send picture if interested. I am in Ontario Canada.How is $20 plus shipping?
I have a pair of bases in beige if your hunt for the black ones becomes futile. Model shops usually sell black plastic spray paint. It smells really
good too!!