Recent content by bearwolf64

Maybe it because there no tires or pressure on the suspension?

Two more questions: 1. Installed new tie rod links, after I torqued them to 40 Ft lbs the outer tie rods don't seem to be level with the bottom of the knuckle arm. Is that normal. I attached a picture. I just went out and measure the angle at about 15 degrees. 2. Any idea where I can buy a...

memike Outstanding THANKS...……...

I am looking for the torque spec for the idler arm bushing bolt on a 1975 Valiant. I attached a picture of the idler arm. The red arrow points out the bolt. The part number is MasterPro K7086. Here is a link to it...

Everyone I had the CHP stop by to verify my VIN on my two Valiant(s). My 64 convertible's VIN tag is missing. He told me if I could get a blank tag he would get it stamped for me. Doses anyone know where I could get a blank 64 VIN tag? Thanks Bearwolf64

All I pulled off the fuel inlet fitting and is was stripped. Any suggestions on fixing? Bearwolf

All I brought a used Weber 8867 carb for my 67 273. While installing it I discovered the large brass fitting that the fuel feed line attaches to does not tighten up. It is acting like it is stripped. Two questions: 1. Is it suppose to spinning . 2. If is there a way to repair. I...

All I am looking for the hold down clips for a 64 Valiant convertible top. They are the white plastics clips that mount to the metal strip. Thanks Bearwolf64

All I may need to transport a 1963 Valiant (convertible with a 225) from Triangle Va. (22172) to Windsor Ca. (95492) I am in the process of trying to sell it, got laid off. If it does not get sold we would need a pick on or about the 26th of May. Thanks Bearwolf64

Selling my 63 baby blue convertible. 79,000 original miles, 225 single barrel, dealer air, power steering, push button auto trans. New top, hyd power not working but have all parts. New brakes all around. Motor rebuilt two years ago. Asking $5000.00 to a good home..... Have a 64 convertible but...

I got a 64 two convertible with a 273 and 4 speed....

Here is our 63 with a slant six and push button automatic transmission and our 65 with a 273 four barrel and 4 speed on the floor. Bearwolf

winsroninwisc Do you have pictures? Bearwolf64

All I got a Carter Ball and Ball carb and I can't find the ccrb number to order a rebuilt kit. Here are the numbers I could find on the carb: On the side of the barrel 6 1697 On the top of the bottom plate 1-1746 On the bottom of the carb 1-1707 There is no tag on the carb. thanks...

Kenicb Do you still have the 2 barrel intake and linkage? Bearwolf64