Recent content by Dakota_Don

Hello, did you ever get it working? does the B van PS bracket bolt to head differently then the truck PS bracket??? thanks

Hello, I have a 98 2.2 amigo with timing tensioner issue, per the instructions with new belt I align the pointer to the window for the NEW belt.. it took several attempts to get the mark to hold this position.. after putting about an hour on the belt... the mark stayed put.. but now its moved...

will this conversion work on a LA headed 72 360? anyone with pics.. fyi the LA heads do NOT have the same bolt holes as the magnum.. Thanks [email protected]

will the tensioner make any noise as the chain beats it to death?

2000 stratus, the batt light comes and goes.. the alt was checked and ok, the batt tested ok, wiring looked ok, so far every thing looks good, charges 14.2 -14.5 volts with the dvom..I know the VR is in the pcm, but would that totaly stop charging/overcharging if the pcm was bad? also will the...

using a 72 340 new pump..

I didnt think about the secondaries..humm

this has been an issue since i had the carb.. so i wanna make sure everything i the cab is ok or close where it should be..

it has the 8.5 in it now, has a stock 72 340 new fuel pump... all the efi stuff is gone.. its wired and plumped like the older 70s mopars

the carb in question is a 770 avenger vac secondaries. the engine is a SB 410 cid, xe274h hyd flat tappet cam 4in stroke and 4.04 bore ported 2.02 and 1.60 valves cast iron heads eddy rpm air gap intake.. long headers.. auto 904 in a dakota with 355 gears the carb has 72 jets, and what...

Hello, working on a 72 360, it has been decked bored and stroked.. anyway i do not like my cheapo adj rockers so off they come.. i have a new set of stock type stamped rockers.. now i do not want to just throw in a set of stock push rods.. so I got a PR checker from comp..Now with the 1 cly tdc...

anyone from there, I have a 68 dart 4dr that was purchaced 10/18/67 by James Husmann ( husmamn) or Husmann.. of Hoyleton IL. vin LL41f8B###### Looking for info,photos ect of the original owner and the dodge dealer in Hoyleton Il. Paul Fark & Son dealer number 54604-002 Dodge cars & trucks...

thanks

hello, 72 360,.. decked with unmiled 70-72 cc heads.. .039 head gasket.. not sure of the deck height.. any way i want to use stock style hyd rockers with shafts.. since my deck is decked id like to check the PR legnth. i set number 1 cly TDC, rotor pointing to no 1 cly...anyway i adj the rod...

thanks