Recent content by daniel9843

Much appreciated all, its all been a great help. will let you know how I get on with all the ideas. I did forget to mention that I'm running a MSD pro billet distributor with the crane H I 6 setup, it is magnetic pick up. if that's any help

Hi all , thanks all for your input will take all on board . Bewy can you just connect the thin red wire to the original coil wire or do you reckon connect straight to the wire that bypasses the ballast resistor?.

Hi all, Just wondering if somebody could help with my ballast resistor bypass on how to wire it correctly?. I live in Australia, this is a Chrysler Valiant VH series 1972 wiring diagram supplied. I have a 1 wire altenator in the system now and a crane H I 6 ignition system. I have bypassed the...

ok sorry Loco, i am just after a low 12 sec pass with these heads my car weighs around 3500lb just wondering weather im heading in the right direction..

standard out of the box,

that sounds promising, i will just be running the valves that came with the head set as close as possible to 1.650 installed height hopefully i dont run into to many dramas with valve geometry.. Im fairly new to all of this ,will be running a hydraulic voodoo cam hopefully im heading the right way?

thank you most appreciated, are you impressed with these heads ?

im putting them on a 360 block

Hi there, was just wondering if anyone knows of the correct gaskets ie cylinder head to use with the RHS indy heads to suit LA block, i have heard there can be some sealing issues around water gallerys on the head surface area. Also the intake and exhaust dont seem to be a real good fit .. i...

spare j heads dont come easy over here in Australia it would be nice...

they are fairly ported went a bit heavy on the short turn

the moroso ceramic seal sounds good, but how long will it last?

yeah that was under pressure test the slight leak was noticed. no body will weld it as its to thin in the area

Hi there i was just wondering if many have come across this problem. I have a set of J cast 360 heads with a pin prick size hole in the intake short turn, i am a bit worried about putting these heads on as the hole is on top of the coolant gallery. I have been told to put some sort of chem weld...

thanks all for your help will let you know how it goes