Recent content by dart14

Looking to Redo the front split bench seat in a 73 Sport Dart as I picked up a set of Legendary covers at Carlisle this year. I pulled the existing cover off of the drivers seat back and the foam for the seat backs needs some repair, but overall is in tact. I planned on purchasing some high...

mine measures about 3 and 1/4 inches

I bought the fake woodgrain for a standard a body dash redo. Looks great, fits perfect, easy to install. DMT has good quality stuff.

I should have mentioned that the picture of the inside of the dash panel is actually a 72 with the tangs from a 73 JB welded in. The 73 hole for the hvac controls is a bit larger than the 72. To refinish the dash panel woodgrain, I would use the decals from Detroit Gasket. They fit well and...

the heater controls attach to two studs that are screwed in to the backside of the center ip bezel and are also attached to (pass through) two mounting tangs that are connected to the ip frame with two small nuts. you can see the studs protruding through the tangs ( a couple inches above the...

thanks for the replies. Guess no one will ever see it anyway. Just didn't want to make an obvious mistake while I have it out of the car.

i purchased a nice ash tray assembly from e bay. After sanding & painting, I assembled the tray and frame assy to the dash and noticed the lower gap from tray to frame is about 7/16". Is this correct, looks a little large to me. The fit is fairly flush at the top of the tray and overall it is...

Sounds great. I am about 5 mins from Lewisville Rd. I will send you a PM for the details

inbox should be cleared now e mail is[Email removed by staff]

Looking for a crankshaft pulley for a 1969 318 . 2 grooves p/s & alternator. Measures 6 5/8" diameter x 2 1/2" deep. Can trade - I have a spare 4 groove 7" diameter x 3 3/4" deep

what condition is the speedometer in ? Is it completely rust free ?

I am going the other way as I purchased a 72 duster dash frame to replace my rusted out 73 sport dart dash frame. One thing I just noticed today is that the center bezel area is different. The rectangular opening for the vent controls on the duster dash frame is a little smaller than the sport...

followed rustycowl69's advice and heated it up slow cooled as best I could and got the the tap to bite and completed the new threads for the helicoil insert. I tried cutting a helicoil down about 60% of the length, but I couldn't get it to insert and seat properly. Inserted a full helicoil and...