Recent content by Dartman1967

engine rebuilt in july 2015. tranny and brakes serviced in August 2015. new top to be installed included. A daily driver now- -a little work and it will be great. 11K firm or possible trade-- buyer responsible for transport. Located in Michigan

See earlier post by Dartman1967. Price change is 12500.00 obo

has a rebuilt 273, xtra large chrome radiator, new seat belt to be installed, rust proofed entire bottom (Michigan car-protects against rust and stones-not driven in the winter). new vent assamblies, new custom top with glass window to be installed. Reason for sale is due to back surgery. It...

Car and various parts for sale including new convertible top however, the current top is ok and the mechanism works great. Some trim parts included including the original radiator and vent windows and parts. Additional pics are available. Replacement cost is estimated at 18000by insurance...

My Dart doesn't have the kick down/passing gear. Is it ok to drive it without this? There is nothing missing on the outside of the tranny that I can see that is missing. Any comments or suggestions are greatly appreciated as I am getting ready to sell it. Thanks

Thanks for the response. The guys that are doing the work for me have said that the front drums are 10 in with "friction pad" of 37/8 inches while the rear is 10 in. with the "friction pad of 21/4 inches. the rear studs measure 5x 41/4. Does this make sense to you? is the 5x41/4 stud...

My 67 dart gt has rear drums that are 10 inch with the pad surface area 2-1/4 inches. I am told that the car should have 9 inch rear drums.....if the rear end was swapped out how do I find out what year it is? Thanks

can anyone recommend a reasonable engine remanufacturer in the Grand Rapids/ West Michigan area? Thanks

Anything else besides the push rod? Brackets? Lines?

I am in the process of adding power brakes to my 1967 Dodge Dart GT convertible before I sell it. I will just be adding the pump and not going to disc brakes. I could use any help as to what additional parts/brackets, etc that I will need to do the job. Thank for any and all help.

lost pm please resend

Well I have a mini-project 1967 dart GT Convertible. I also have some friends that maybe looking. My Dart has documented 49K but sat so long seals and stuff needs to be redone. Has a new top and body is great, tranny is good, early 67 no pwr steering or brakes. starts every time,etc

Hey guys thanks for the help...I checked at the torsion bar---didn't see anything, talked to my neighbor who bled my brakes---he is missing a jack cup. I am trying to figure out how it "fell off" 3 blocks from home. My potential buyer just laughed when I told him why I was late. Too bad he...

Hey guys-here I am again the tech. impaired owner. I was driving down the street to show the car to a potential buyer and this fell from the bottom of the car. What the HELL is it. Don't know what to look for in order to replace it. Any help is appreciated

Pulled from a 67 273 Gt. needs to be re-cored. $125.00 plus shipping