Recent content by dave273dart

My plastic operating lever in the steering column broke loose and fell into the steering column tube. Does anyone know where I can get a replacement? Sure appreciate any help. Thanks Dave

I was doing a little reading about alternators in this forum. When I restored my 67 Dart I upgraded my wireing harnesses with new wire if needed. When I installed my electronic ignition system, I also upgraded my alternator to 78 amps-I purchased one for a 85 Dodge Pickup D100. It fit with out...

In 2005 I put in a mini starter from Advance Auto Parts in My 67 273 Dart. I purchsed a starter for a 1992 Dodge Dakota 318 ci. Have had no problems. It fit right in. Dave

Wilbanks, Any word yet. Thanks Dave Davis

Wilbanks, I forgot to ask about cost. Thanks Dave

Lee, I am only looking for the RT and LT lens, thanks though. Wilbanks, I am interested. Do you have both RT and LF and pics. Are they in good shape? Thanks Dave

I am looking for 67 Dart Front turn signal lenses. Any help will be appreciated. Thanks. Dave Davis

Has anyone mounted a tach on the steering column or some place else without drilling holes. Thanks Dave

I used rtv on the ends. The guy said that if it became necessary he would replace the heads. Sometimes the simplest things can stop a train. After I installed the intake I put he carb on the, first the gasket and then the 1/6" plate. What I failed to do was put another gasket on between...

RedFish, I think that you are correct about the calculations being are flawed. I will take your suggestion. I just don't want to take everything apart again. I am going to request that the guy get me new heads. If need be I might retain an attorney. My wife pays $7 a month for attorney...

The heads were originally milled .050. I never had the 340 Intake milled. The new intake was milled .080 sides, .090 ends. I used the Edelbrock composit intake gasket (.060) the second time I installed the Edelbrock intake. I am still getting a leak on the right side. I used carb cleaner and...

It sure is a lot of $$$$. It's really something I need to think about. USPS probably isn't much less. Thanks for the info. Dave

Cuda, Are the 920 castings 273 heads or the 318 can"t remember. Let me know cost and shipping to 32043, Green Cove Springs Florida. [email protected] Thanks Dave

My third time-still a leaking problem on the sides, even with the composit gasket and rtv. I have tightned and re-tightned. I need to talk to the guy that did the machining and see what his other solutions may be. I guess the only logical thing to do is put on other heads. It's trying to...

Another problem I have run into is-trying to torque 3 bolts. I have ft lbs and inch lbs. The 3/8x3/8 socket fits but there is no room for a flex extension or the wrench. I am using edelbrock bolts, 3/8 12 point. The first time I used a 3/8 wrench and guestimated 25 ft lbs and gave it an extra...