Recent content by Dodge 340

I have installed a 7576 Edelbrock intake with a 4160 Holley carb on my 340 engine. With the intake being higher, the throttle cable bracket sits too low and my throttle cable is at too much of an angle and will wear on my cable. I would also like to get a billet throttle bracket assembly with...

I have the column apart, I don't see an actual LAMP, but there is a curved metal tube(for no better way to put it) that has a wire to it that goes right around to that area. But again I don't see a lamp, it may be internally in that tube.

How do I find out if I have the A01m package? Would it be on the vin plate?

I am restoring a 70 Dart Swinger and am currently restoring the steering column. Does anybody know if there is a lamp internally in the column to illuminate the key area or four way flasher or anything?

I will check, thanks for the information.

Should they be 1-1/4" long for bell housing to block?

Thanks, I didn't think I had them mixed up but I could have. I thought the intake bolts were shorter than that but not sure. I will check. Thanks again.

working on my 340, 4speed, 70 Dart. started restoration probably 15 years ago and am now working on the engine. The bolts that I have marked for bell housing are 3/8-16X1-1/2". In trying to mount the bell housing, the bolts bottom out before the bell housing is drawn up tight. What am I missing...

I have a 1970 Dodge Dart Swinger that I am restoring. Can someone tell me which rear jack mount is to be in this car. The one that was in the car appears to look much like the ones for the B and E bodies but the description for those say that they mount on the left side and suppliers don't seem...