Recent content by Fab_64

Note: This car has a column shift (not console). More pictures: Since I posted the first pictures on July 10th, I've installed a new trunk weatherstrip, which allows the trunk lid to sit lower and fit correctly. This was a quality piece, obtained from Detroit Muscle Technologies: Mopar...

Price drop to $17,500/OBO

Unfortunately, that's probably true. I'll keep looking for one locally, but will keep you in mind. Thanks!

I've converted my '67 Barracuda to Large Bolt Pattern, front & rear, so now I need a wheel to use for a spare tire. Prefer standard width (5-1/2"?), as I want it to fit down into the spare tire well. I'm located in So. California. Let me know what you have. Thanks for the ad, FABO!

Hemi Orange (originally White), tan interior 89,268 miles (TMU, but I strongly suspect this is true mileage) 225 Slant Six, 2 bbl carb., 3 spd. Automatic trans. Clean title, in hand. Mechanical work performed while I've owned the car: Stock engine & transmission rebuild at 84,400 miles Front...

Hi all, While my 225 is out for a rebuild, I want to replace the motor mount and transmission insulators: 2806842 - Right side, motor 2806844 - Left side. motor 2533145 - Transmission (auto) I know the tranny insulator is available from 440source for $19.95 (part 101-1069). Does anyone know...

I'm putting a Super Six carb and intake on my Barracuda. I'm picking up the carb rebuild kit today and am looking for a throttle cable. The one that's in there is too long, and the correct replacement (2899336 or Y156 or CA-8417) is getting harder to find. I've heard the ATP and Pioneer items...

Do you have any pics you can post? I'm thinking about doing the same thing. Thanks!

So does: "pack my box with five dozen liquor jugs" but it uses four fewer letters. :toothy5:

I just had to replace a wheel bearing on my 7-1/4" a few weeks ago. I tried the slide hammer for a while and it wasn't budging. I then tried it again, really applying some force (wailing on it) this time, and it finally started to come out. I was afraid I might have damaged the axle flange...