Recent content by ggt1_02

Location: Livonia Michigan A904 transmission from a '67 valiant for sale. It is taking up space, I no longer have the car it was aquired for. Also included is the torque converter which has been stored with fluid. More photos can be taken if needed.

Livonia Michigan. $3,000 or best offer, I am planning on moving and new garage will not have room for her anymore. '67 Barracuda Fastback, 2bbl Carter NOS carb, 273, automatic, front bench seat. The front suspension components are all new including sway bay lower control arms (have sway bar...

If I recall correctly is attaches with two bolts on the bottom of the fender, the tabs can be seen on the fenders in the picture. Mine was put on with multiple different size bolts though.

Not a fan of the new dart overall, but I don't really like mid-sized cars that much. The Hellcat is sweet and the sales numbers are insane for the Challenger as a whole right now, which will work perfectly for me in about three years when I should have the funds for a nice three year old R/T!

The zinc is AFIK used as a sacrificial metal for corrosion, it will be attacked instead of the steel. Similar to zinc anodes on the side of ships.

Without hearing a sound clip, I would say it is most likely normal. Depending on the year in my experience at least some years are louder than others. I had a 2004 and a 2006 truck which were really loud, my 2009 Jeep is not as loud. The sound does go away after it warmers up.

You don't mess around do you? It looks nice shaved down. I think the center needs to be there as well.

Looks very nice, may do something like this eventually.

I have a run of the mill 67 fastback, nothing special just a 273/904 both of which need a full rebuild. I am planning on a 5.7 with 545 swap. If your car is a super clean example I would lean toward keeping it as it is. If it is like mine which needs lots of work, might as well well make it...

At least nobody was in the car with him or was collected in the resulting carnage. We had an incident here where a Hellcat was travelling at high rate of speed in traffic and was captured on dash cam but not caught. It started a discussion on the local car club's bookface page about some guys...

This got my mind working yesterday and I talked with a guy who used to build hot rods. He would weld in some round stock between where the glass would go and the body to fill the glass to get the flush look. I think on our cars we would need a piece of flat stock to raise the glass to flush...

I have a set of housings laying in a box....

Looks great

The part numbers you listed earlier are the same as the ones in my 2009 Grand Cherokee parts manual for the 5.7 engine, the only thing that changed is the removal of the EGR valve which happened I believe after '07. It's the only parts manual I have so I can't say anything about compatibility...

Sounds a bit steep to me having had a couple 3.7s in the past. All of the maintenance on it can be done in the driveway, plugs, TB cleaning, diff and transfer case fluids. The only thing I can think of is depending on what transmission it has, if it can be serviced by the owner or needs the a...