Recent content by GJSZ51

  1. GJSZ51

    Torsion rod adjustment

    Thank you for the link!
  2. GJSZ51

    Torsion rod adjustment

    Thank you, krazykuda! Exactly what I was looking for. Perhaps I will buy a service manual. Now that I am finishing
  3. GJSZ51

    Torsion rod adjustment

    I do not have a service manual. I had the good fortune of disassembling a very complete car and am good with a camera and labeling. I do, however, have a number of measuring devices and the skill sets to use them! Thanks for the help!
  4. GJSZ51

    Torsion rod adjustment

    Do you set by torque or measurment? Is there a specified "procedure"?
  5. GJSZ51

    [WANTED] 1965 Barracuda misc. parts

    Think I can do a lot of hammering on the ones I have for 300 bucks!
  6. GJSZ51

    [WANTED] 1965 Barracuda misc. parts

    I have not been on Laysons site for quite a while. I will check it out. Thanks for the tip to Classic Industries!
  7. GJSZ51

    Torsion rod adjustment

    My 65 Barracuda resurrection is nearly complete. It is running beyond break in but has yet to move 1 foot under it's own power and that moment is upon me. I like it's stance as it is but it occurs to me that, beyond suspension assembly, no other adjustments have been made. In fact, none of the...
  8. GJSZ51

    

    
  9. GJSZ51

    [WANTED] 1965 Barracuda misc. parts

    I am searching for an emergency brake handle. Just the plastic, I have rebuilt the mechanism. I need the headlight bezels. I have several pairs that are pretty well beat up. Rear window trim (what I call the trunk belt} All five pieces. I have two sets, 1 of average driver quality that I am...
  10. GJSZ51

    [FOR SALE] 1963-1966 Early A-body Gas Cap

    Thanks, Joey and, thank you, Steve. I'll place an order
  11. GJSZ51

    [FOR SALE] 1963-1966 Early A-body Gas Cap

    I would like to order a cap. Is it best to order from you here or use Ebay?
  12. GJSZ51

    273 coolant leak

    Thank you, everyone. It is a very sweet little motor! Glad to know of the coolant passages. I'll know to drain the radiator if manifolds need to be removed. Thanks Redfish I must admit, I was near panic mode! Thank you Rocky_JS and Grimreaper. Time for a test drive...
  13. GJSZ51

    273 coolant leak

    ...understatement... As some here know, I am nearing the completion of my 65 barracuda. Essentially stock build on a 273 with a factory 4 speed. Had to move out of my shop last October, then got sick (understatement). Anyway, brought her home and fired her up for the first time before illness...
  14. GJSZ51

    [WANTED] Speedometer cable

    Looking for speedometer cable for my '65 Barracuda with 273 and 4 speed. Thanks for the help, as always! GS
  15. GJSZ51

    Timing the 273

    Pretty much as I figured. Now I am curious as to weather or not this is the original engine for the car. I will replace the timing cover and water pump. Yeah, radiator too. How can I date the block? Should have looked into this before I started. Motor was already out of the car... The...
Back
Top