Recent content by Gordon Selbig

If it has large ball joints, it is probably the same.

I’m looking for 1973 to 76 upper a arms. Must be for a disc brake car.

What is your price and shipping to Michigan? Also condition Thanks

My stainless on glass got knocked off and bent. It taps on glass and helps seal next to the quarter window.

I have a 67 barracuda that needs a correct wiper arm and refill. There are so many out there. My one has red push button on it. Need another one if it correct. Any thoughts?

I used PPG Shopline round $112.00 a qt and PPG 2021 clear. I don’t know how it will hold up, but it looks very good.

I always hear about someone welding in a spare tire well,but I was thinking about making it deeper to handle a possible 70 series tire. Has anyone ever done this before? Thanks

If If you live in a warm climate. Foil works best with a minimum 1 inch air space. If you have easy access iwould install it 1 inch below your roof decking.. Then I would insulate the ceiling with a foot of fiberglass or blowin. . This would give you the best bang for the buck to stay...

I used a slide hammer to remove dip stick tube. I tapped a bolt to fit, put locktite on it.let it set a week. After 12 slides ,out it popped.

I found a chrome one from Autozone spectre 5721. Says it fits 318;340-360 was to long ,going to cut it and use old dip stick. Haven’t removed old one out ,yet

I wiggled my 318 dip stick tube to pull it out,to replace it. It snapped off.I checked a 273 and the tube length is shorter. Any tips to remove broken tube. Thanks

I’m working on a 67 air conditioned Barracuda. I’m wanting to replace the hoses.What is the correct size?Is the rubber block connector available? Also,some hoses have stripes on them. Any info would be helpful. Thanks