Thank you for the quick response 2manymopars!
I bought a reproduction off of classic industries, if I am not happy, I will contact you right away as I will buy from you.
Looking for a passenger side front splash shield for my 65 Cuda that is in good condition
Without rust. I live in normal Illinois 61761. This is one of the last pieces I need to make the car complete. Thank you!
Just installed these in my 65 Cuda with a 340, IMO, They are an extremely tight fit..... But with the alterkation things would be fine. Without an Alterkation, I would go Doug's headers as their fitment is better in the early A body.
If you have been ripped off by Brian Lange- please contact Deputy Rauch immediately.
Deputy M. Rauch #4005
Orange County Sheriff’s Department
Economic Crimes Unit
[email protected]
714-647-4163
Hello everyone-
I need the sage advice and wisdom from all your mopar years/experiences. I am currently replacing the 318 w/fenderwell headers in the car w/a hotter 340 (.20 over w/ported pro comp alum heads) and tti headers. The engine compartment has been degreased, freshly repainted...
It was a bad ignition coil.
I replaced the Mopar Performance coil part number 4876732 with an Accel 8140C coil- running fine. Need to get it out on the road and test to see if there is a difference at all.
The car does not start after I turn it off.
Time span is typically immediate.
I have only had it idling for a while so not 100% sure it is running right when it is warmed up.
I have not yet looked for vacuum leaks- will do...
Hi everyone-
My 65 cuda started right up after 4 months of storage. However, once the car has ran a little or is warm, it does not to start again. Looking for suggestions.
Thanks,
Illcuda65