So I would say you need to trim before you roll, the more metal you have on the lip the more stretch youre going to have to deal with as you roll it over. Also, use a heat gun (this is to make the paint more pliable so it does not crack).
yes i have read all about that. I know what the risk are and as someone else said, if you can smell the paint then your not safe. I always paint with well ventilation in the garage. I use a respirator mask and filter setup for painting. If i smell chemicals i stop. And yes, i learned the...
so here is my experience. 1 follow the datasheet for the primer you are using. i just use a cheap hvlp gun (100.00 range) for primer. make sure it has the needle size recommended on the datasheet. I have a 60gal compressor, but i think you could get away with a 40, maybe 30 or so. I dont...
i dont remember a thread, but i did see it as a solution to an issue on the show engine masters. they had to notch the plenum to get the EFI to run right. I do have EFI but running a single plane. i think it may have been this episode
ahhh, didnt assume he was staying with a smaller diameter wheel. So yeah the sidewall flex will hurt him much more then someone running a 17 or 18 :)
yeah i rolled the Lips almost flat up top. Also running a dana 60 (hub to hub measurement was 57 1/2) in the rear with QA1 adjustable shocks...
that guy does really good reviews, his reviews were the reason i gave Tekton tools a try and so far have been impressed with, i have heard good things bout both harbor freight brands "yukon and us general" i have the husky box thats in that video, i am happy with the box, if it was used for...