Recent content by LarryB340

I'm using a Champion 4 row with a Deraile stainless flex fan rated to 10,000 rpm with a custom shroud on my 340, 69 Dart, its working well. Also using Evans Waterless Coolant and a 180 degree thermostat. I have yet to see Temps over 190 degrees.

gonna upgrade to 95 amp one wire alternator, I know I need to bypass ammeter, if I run a new heavier charge wire from alternator too starter relay and tie ammeter wires together, where do I get power for the rest of the accessories, key switch power etc.? Do I connect the original alternator...

Thanks again, just ordered the bracket and return spring bracket, looks like it will work great.

Thanks! Yeah its an A833 four speed, ill look into it.

if I knew the carb pad height on a stock intake I could do the math and figure it out. I know the airgap pad height is 5.35 inches.

1969 date code 340.

I am having trouble getting full throttle on my Holley 4 barrel carb. I have an aftermarket cable bracket, the original bracket is too short because I am running an Edelbrock air gap intake. I can't use the mopar adapter on the carb because of the design of the cable bracket. I've tried...

Hey guys, I appreciate all the responses, a few things about the carb, it is the way I bought it used on e-bay, I took the primary main jets out, 76 and put in the 72s. The main air bleeds were a suggestion from a friend, it has a new holley baseplate with a check ball in the power valve...

They were at around 1 turn out, then I blew a power valve and it got even worse. Its a four corner idle. I have the carb off and apart at the moment, just looking for a good suggestion on jetting.

I have a 0.030 over 340, 10.5:1 compression, Edelbrock air gap intake, headers, big valve "J" heads with mild port work with a .513/.533 lift, 234/242 duration @ 0.050 Lunati Voodoo camshaft, backed by an A833 four speed and 4:10 8.75 Sure Grip. Topping it off is a Holley 750 double pumper with...

I have a 1969 340 Dart Swinger, the transmission is original to the car, I'm wanting to order a rebuild A833 from Brewers. Can anyone tell me the diameter of the front bearing retainer and tail shaft spline count? They offer 4.354 and 4.805 diameter retainers. And will the output spline count be...

Can someone tell me where the post that hits the canceling cam is located? I have a Grant steering wheel on my 1969 Dart Swinger. Is it a post on the back of the steering wheel hub, or a spring that goes between the wheel hub and steering shaft? Where do I find the part, part number for it? Just...

What are you guys using for cable and bracket? I have a 1969 Dart Swinger, 340 holley 750 double pumper sitting on an Edelbrock RPM Air Gap manifold, four speed car, looking for suggestions and sources. The stock bracket and cable are not going to work.

Yeah a good recovery system would be a good idea a $46 a gallon. I just like the idea of no water, no corrosion. Thanks for your input!

Thanks, I was looking at their website and must not have gotten to that part, was looking in FAQs.