I put a 1" spacer under my 750 mighty demon in my 67 Barracuda. I needed a new bracket to hold the cable. I got this All54225 which fits nice but now the Mopar throttle extension lever does not fit. The manufacturer website has nothing. I cannot find a stud that fits a 3/16 hole on the Holley...
If there is a way to easily get that info, i can check it quick. Otherwise, i don't know.
This is the only other info on the website:
Primary Discharge Nozzle Size (in.):
0.031 in.
Secondary Discharge Nozzle Size (in.):
0.031 in.
Engine: 408 magnum Aluminum heads 10.6 compression single plane intake
Cam: 241 247 @ 50
Carb: 750 Mighty Demon mechanical secondaries
Primary Jet: 72
Secondary Jet: 84
Inner air bleeds: 38
Outer Air bleeds: 93
Power Valve: 5
Annular booster
This is in a 67 barracuda with 4 speed trans
I have...
I noticed a very distinct vibration in my car at 4000 RPM only. Below and above that, there is nothing. The car does not shake but the vibration is very noticeable. The vibration occurs when driving and parked, clutch in or clutch out. I have have had new motor in the car for about a year and...
Took the third member out of my 8 3/4. I understand the case is a 741 but i'm not sure what the LSD is. It does not look like sure-grip units i see online. Can anyone identify what brand/type it is? The whole setup is behind a 500 ft-lb 408.
I am trying to wire a 6 AL box into my 67 barracuda. I tried to wire it to an open fuse, like a tachometer, but those 12v sources turn off when cranking. I know everything works because i wired the small red wire directly to the battery to test it. Does anyone know of a keyed 12v source that...
I am trying to install my new magnum 408 with Hedman long tube headers. car is a 67 barracuda, manual steering, manual brakes, manual trans. I have no clearance issues with them but i cannot get them installed. I tried putting the engine and trans in with the headers loose in the engine bay, no...
Trying to learn more about my 4-speed. I have Passon's book but im still not finding too much. The tail shaft is stamped "C39126-3" or "C99126-3". The book says the 99126 was used from 69 to 71. The car its in is a 67 barracuda and the car it is believed to come out of is a 72 duster. What does...