Recent content by mikebarg

I'm selling my 1962 Dodge Lancer GT project. Located in Hutto Texas, near Austin. Fairly clean body with little rust, solid floor boards and trunk. One of the rear quarters has rust bubbling up. Has original 225 engine and 904 tranny. Engine runs, but smokes. It is currently pulled from the car...

I'm selling my 1962 Dodge Lancer GT. The body is in decent condition. Some rust on the rear querter. The drivers side front of the hood has some bondo and the front edge of the drivers side fender has some bondo also. I have another hood and fender. The Engine is a 225 /6 it was running when i...

That's mean. If you are going to run that down the track somewhere here in central TX let me know. I'd definately like to see it.

Well, if you want to load them up you could put them in a press and load them up, to what pressure,I don't know.

VERY NICE looking setup. I hope mine will look 1/2 as nice when I'm finished with it.

My 7 yr old son was reminding me to close the garage door because I already gassed the garage out once before with gassie/carbonie fumes.

I got the 225 /6 on my 62 Lancer to start on Saturday.And,much to my amazement it kept running with old gas, rotten hoses, and frayed belts. YouTube - car 005

I just got tires for my 62 Lancer. I went with 14" wheels instead of the 13s. The availability of 13" tires isn't great, 14s aren't that common any more either. You could order them online and have them mounted by a local shop. I have 185s on the front. If your not going for pure resto, go with...

My 1st choise would be a set of 14" crager SS wheels. I want to stay old school and use 14" wheels. So,this is what I have to work with for now.

I had a pair of ralley wheels with no center cap or trim ring. I painted them black. Here they are with 215/70/R14s on the back of my 62 Lancer. It still needs chrome lug nuts.

The wagon's looking good. Welcome to Texas.

I found one not to far from home. Hopefully I can go check it out tomorrow morning. Thanks everyone for responding.

Thanks for the replies. Daredeveil I am going to PM you.

I have 3 14" steel SBP wheels and one 13". I need to find one 14" stock steel wheel(SBP). I'm in the Austin Texas area.