Recent content by Patch

Picked up a set of seats out of a 65 Barracuda for my Dart, but the drivers outboard slider/mount is missing. Let me know....Patch.

Hey all. Picked up a decent set of bucket seats out of a 66 Barracuda. I'm planning on using them in my 65 Dart. For 66 the seats went narrower for console fit correct? I'm also missing 1 track off the drivers seat. Any issues other than reinforcing the floor with brackets? (Original bench seat...

Left-over NOS kit from an ADDCO bar I sold. $50 shipped to your door. I'm located in Oak Harbor, WA. I accept PayPal or USPS money orders. Please ask any questions you may have and thank you for looking.

Hi all....going to start doing basic body panel repair and replacing. For the average home garage, do I really need a 200-250CFT bottle for 75/25 mix? Opinions?? Thanks.

SEND IT!!!! lol....Naw.....after the pictures....it needs some lovin' to fix that correctly.

Hi all....I've never driven my 65 Dart with an 8 3/4 yet, but I do have a 741 chunk (non SG) Is it worth holding onto? From what I have seen over the years, it doesn't seem that they are that wanted. I'll be putting in a SB 408 with a 4 speed and going with a converted and narrowed truck D60...

Great info from ya'll! I converted from a slant six, so I never had a 9.5 V8 housing...was hoping I wouldn't have to go that route. I am planning on going internal balance as my 360 is going the 408 route. Looks like I have quite a few options here....thanks again!

That is excellent info....thank you very much!

Modify the clutch linkage as in the z bar or the pivot point? If I run a hydraulic clutch that may eliminate some of the issues altogether maybe....thank you for your response.....

Hi all.....I thought I did my due diligence, but I cannot find it. I have 2 bell housings......2892482 and 3515734. Brewers says A body and some E bodies, but can I use these at all for my 65 Dart with a 360? I cant be stuck with a 9.5 housing....right?

Lee Robinson just had some early A/C stuff...but I think he might have sold it all....couldn't hurt to ask him....

Thank you all for the info!

So places that do the dipping have epoxy vats as well?

Hi all.....have any of you had your shell dipped? If so, what did you do about the area between the upper and lower windshield cowling? I have both of mine removed right now to replace sheet metal due to corrosion damage (65 dart), but am wondering should I leave my outer off until it gets...

Lee.....you are the man! Thank you!!