Recent content by retrorobot

Have you checked with Wildcat Mopars? They're not too far outside of Portland. https://www.wildcatmopars.com/

This is a 64 Valiant tail light housing that is broken below where the reverse light lens goes. Maybe OK for a beater as is or if you're creative enough, maybe it can be repaired. If you want it, just pay for shipping from 92120 and it's yours. I believe this is a passenger side piece but I...

Hey Jack, I have some extra manifold nuts and will send you one. PM sent.

Can't say that I've done this but your post reminded me of reading this short article: install-review

Do you know if this can be used for a 2 barrel (Holley 2280) on a super six setup or is it specific to the Offy 4 barrel? Thanks, Gerard

I just checked my 63 Valiant with no engine installed and its about 25" from the center of the K-Frame to a central rib on the underside of the hood. Then from the mounting holes where the motor mounts bolt to the K-frame (no motor mounts installed) it is approximately 22" to the bottom of the...

I have 2 sets of front turn signal lenses and 3 housings with harnesses for a 1964-1965 Valiant. One set of lenses is in better shape (cleaner and clearer as well) than the other. I haven't tested the function of the housings or harnesses. Please check the pics and PM me with any...

I tried today to make some out of flat washers and came pretty close, I'll probably use them temporarily. And yeah most likely they'll turn up somewhere random. I took too much apart over too many years to keep good track of everything...lesson learned

Hi, I'm looking for 2 rear shock washers, the conical type for my 63 Valiant. They are the outers, 0.5" ID 1.5" OD. I have the rest, but have no clue where these 2 went. If anybody has extras, please let me know. I'm trying to get this car back on 4 wheels for the first time in years, hoping not...

Got a few extra Holley 1920 carbs for rebuild or parts. These will need to be completely gone through as they've been sitting in my garage for years. They all use the early rotating rod style throttle. $15 each + shipping from San Diego. $40 + shipping for all 3. Thanks!

Thanks! I'm no stranger to buying car parts at the hardware store and in fact I have to make a run there for a random assortment of nuts and bolts anyway, so I'll grab one of these while I'm there.

Great. PM sent. Thanks!

Do you have the door actuators or relays or as the FSM calls them "remote control" units and the rods that connect them to the door locks? They look like this (at least mine do). Looking for a good working set. Thanks

Realize this is an old thread but I have a related question. My 7.25 differential cover had a gasket around the drain plug and I can't seem to source a replacement. I have the case gasket and other parts. It doesn't seem like anything special, just a round gasket but I looked around online and...

Here is a 1964 Valiant/Barracuda Gauge Cluster in decent reusable or restorable shape. There is one small piece of the bezel missing on the back right lower corner and I can't guarantee that the gauges work. $50 OBO plus shipping from San Diego, CA. Thanks!