Recent content by scorpion1110

I can't say honestly. They are as purchased other than painting the fins and smoothing the one weld. I did not note anything that looked like alteration. I think they are original and pretty good. I was going to run them until I sold the car. They are boxed and ready to ship- Had them...

No thanks. $125 Plus shipping is my price on these. if you change your mind email me. Thx.

Not looking for a trade- may have posted these wrong. For sale outright. Bought these for a car that I sold. They are original Cal Custom in nice shape for small block 318/340/360 Chrysler. Had a small repair in one corner - pictured. Nice shape. Repair pictured. I think with some...

Car is sold pending receipt of funds tomorrow. Going to Texas but unfortunately not to a FABO member. Thanks for looking. Wish I could have kept her, but not to be. Dave

I checked this car on the lift last nite. It needs a drivers floor pan and probably a passenger floor pan. Also the rear passenger floorpan that was installed was only 3/4 welded. I am taking care of the rear pan as I have a 220V Mig that will handle it. However because of the extra body...

More Pictures of the Barracuda, including the drivers floorpan that needs replacement:

Price is $4700 and thats as low as she goes. The Barracuda is on my lift and I cant pull it out right now. You can see from the Goldie thread what she looks like. I havent driven it 10 miles since I acquired it in October and its been in the garage on the lift. I did spice up the motor a...

I would like this car to go to an F.A.B.O. member. Its known on this site. I have only listed it here so far. However shortly I will be putting on Craigslist and then Ebay. Its a solid car and priced fairly. Check the thread for pictures. It will probably be on here for another week...

If you go to the thread "Just bein Goldie" you can see pictures of the car including some recent pics of the motor updates. The car is on the lift right now and I havent been able to get it down to take pics. Thank you! S

I have a 1965 barracuda that I have decided to sell due to some recent serious health issues. I purchased the car from an FABO member- You can see pictures on the thread "Just bein Goldie" on this site. The car is clean, factory air, power steering, auto. Since I acquired it, I replaced the...

The fish came home today. It runs/ran great. Starter grenaded about 30 minutes ago. Saturday new starter goes in and we will see if we will be back on the road. I did take it for a cruise before the starter took a powder, found some open flat road nearby and opened her up. She feels...

So its been several weeks since I posted. A new job, home renovations etc. put the '65 on the back burner. However we did find time to collect parts. My daughter was busy collecting clothes. I sense she wants a final product more than the experience of attainment. Though I think welding in...

Havent had time to do much; just started a new job and renovated the garage. So far have removed the aftermarket cruise control, and replaced the battery. The Cuda is in nice shape; but will need a few things. The front bumper is tweaked and she took a hit in right front and possibly the...

Hola- I Bought Goldie from Goldfish1965. Father daughter project and my wife is going to be involved as well. I am a Chevy and Ford guy, dont really know mopars. Have a couple questions on some possible mods on a 1965 Barracuda V8 car with AC What is the best recommended aftermarket...

Sent you a pm. Thx