Recent content by Shane65

Thanks for everyone’s help… after fuel pump, fuel filter, ballast resistor and lots of carb cleaner, I finally checked the plugs. They were filllllthy black, so I got a new set threw them in, poured a large dose of fuel in the carb and it finally kicked over and kept running. I don’t know if it...

It was dying so fast it was hard to tell if it was dying as soon as I let go of the key, it was a really old ballast resistor and cheap to replace so I went for it, but no luck.

It’s seems it’s getting fuel… I installed a new clear fuel filter between the fuel pump and the carb and it’s half full of fuel

Hey FABO, so a few days ago I was gonna take my 318 68 cuda for a spin but it decided it wasn’t gonna start. Tank is about half full… I’ll pour a bit of fuel in the carb, it starts for a second then dies when that fuel burns up. I had a similar problem over a year ago… ended up being fuel pump...

Interesting…What would be your recipe to do that?

Are you running on a stock block? What year? Are you going with solid roller or hyrdraulic?

You guys are amazing… thanks for all the valuable feedback. As a total novice when it comes to this stuff, i just don’t want to buy a hydraulic roller set up then wished I’d went solid… or vice versa. As you can see from some of my earlier posts I’ve been researching heads for a while now.. I’ve...

Looking at trickflow heads for my very mild 318. My car is a street driven 68 barracuda, weekend car, gets probably 3k-4K miles a year if that… i definitely want some HP gain with this project, but not sure what the best route is. If I go hydraulic roller it’ll probably be less maintenance, but...

Anyone have any recommendations for a machine shop or engine builder that knows Mopars in Orange County? I’m in Huntington Beach. Thanks!

Thank you for taking the time to write suggestions. I had a hard time tracking down an LD4B when I was searching a year or so ago however after all my research, many people said the Weiand Stealth is nearly identical to the LD4B so that’s what I ended up with… I’m sure they are within a couple...

Sorry about that, I cleaned up my mailbox, but it says your conversation is blocked... not sure how to unblock it?

What's up guys? Hey so wanted to reach out to the experts here... I'm really wanting to wake up my 318 a bit. I've been researching a lot but wanted to reach out and see what you guys think. I'm debating on buying new heads and a cam to make some power, but I do have a set of old 587's that...

@yotah1 sweet build man! What are the specs on those wheels?! Those 5x4.5?

Please tell me more... narrowed to A-Body width? What process do you use to narrow them? Chop and weld or sleeved? Either bolt pattern? What kinda price range for a complete housing with gears, axles, brakes etc...