Recent content by slim 67

I'm also curious as to what the - number means after the 360.

That looks like a 67 so it wouldn't be an original 340, but chime in if I'm wrong

Inversion tables are awesome for lower back pain. I'm 6'8" and have had trouble for the last 20 years or so with a buldging disc, I bought a tetter hangups about 3 years ago and have had no pain at all ever since. I only use it maybe 2 times a week and it has been a life saver.:cheers:

I used two sets of comp lifters and now have the lunati cam and lifters in it. It has about 1K miles on it and still runs great but still has that annoying noise in it.

I started a thread on here a few years ago with the same problem and got a lot of good responses but never found the problem. I have the same scenario with a roller block ( '89 360) with flat tappets and the noise seems to be drivers side near the front. I changed header gaskets 5 times tried 2...

No, they are not wet, but i would put a little silicon on the threads when you put them back in so oil doesn't seep out. I did the same thing you are doing just last weekend.

Is this large or small yoke?

Is it cone or clutch, and is it large or small yoke?

This set is brand new and never used in any way at all. model # is 11135. $75 delivered to lower 48. pm with any questions.

Wow that is way way cool, you can get sunoco 104 where you live? The best we can do here is 91, without buying race fuel and mixing it w/pump gas. Oh yea I guess the car is ok too.

I also used phenolic washers under the flat washers to help insulate from any heat transfer.

I had heat soak issues with edelbrock avs 650 until I slipped one of those gaskets in and no more problems! I am also running a rpm intake so I had to go with a drop base filter housing.

They suck, I have a thread on here with my story I just had never revealed the company I was doing buisness with. I did finally get the proper springs but i had to put them on myself or pay someone to do it, they would not cover the expense. Same old thing they were nice when I was ordering them...

here's mine

I bought a set of edelbrock heads from a place that uses edelbrock bare castings and loads them up w/their own components. Now for the problem, when I unboxed these things it looked like to me the springs were way to big for the retainers. So when I set the rocker arms and shafts in place they...