Recent content by stoke

I have a 47 Desoto conv, had a flathead 6 in it, but with the fluid drive trans, it had a rough time pulling the heavy conv. So I put a 68 plymouth 318 in it, with a 904 tranny.Went in pretty easy used 65 cuda exhaust manifolds, and made my own mounts. Had to offset the engine a smidgen. Glad I...

What can I use to stop moisture from forming in and around my 65 cuda? It is stored in a Shelter logic round top shelter. Had a good share of it last season. Thanks for any info.

I am installing a lokar shifter on a 1968 904 trans. The lokar has a switch with 2 wires and the stock has just one. How do i connect the lokar switch so the car will start. Thanks

Any ideas on how to fix tranny oil pan leak on my 904? I have changed the pan gasket 3 times and still leaks. What is better cork or rubber? What kind of sealant should I use, I have tried a lot of them. Just looking for suggestions Thanks, Stoke

Could someone measure where the penestar is located on right front fender of 65 Barracuda, Thanks

wanted used or info on where to buy, 65 barracuda 4 speed boot.

I got mine from National Moparts, Inc. Beaverton, Ontario, $3.50 each Phone- 705-426-2993 E-mail- moparts@nationalmoparts.com Don't know how many they have left, you will have to check. Good Luck

I used the b&m shifter from Summit, in my 47 Desoto with a 904, works fine.

Try www.restorationspecialties.com cost $44.00

Does anyone know where I can get a boot for a 65 Barracuda 4speed? THANKS

I will post some pics as soon as I figure out how to do so. If you go to Desoto.org and click on members cars, mine is the red convertible

I took a 47 Desoto convertible in worse shape,into a daily driver. THere are parts out there you just have look a little. The flathead head six with fluid drive is no speed wagon. That is why I replaced mine with a 68 Plymouth 318, with a 904. Check out Desoto.org the National Desoto Club. They...

How do the repops sound similar to the original?

How do the repops sound similar to the original?

Does anyone know where I should start to find the cause of the speedometer needle, on my 65 Barracuda, going nuts ? It goes all over the place, Just asking opinions before I jump into it. Thanks.