Search results for query: *

65 cuda /6. The hole in K member where the strut rod attaches has been worn out of round. It appears there is some sort of support washer, if so, can it be removed and replaced or should I just fill weld the worn area and grind it into proper shape? Thanks for your input.

Looking for strut rods for my 65 cuda

Need trunk lid, mine is full of rust at the bottom edge. These are like finding Barracuda teeth. Thanks

Picked up an 8.25 rear end to put behind my 65 barracuda slant 6 so I could get the BBP axles. Believed the ratio to be 2.76 but as it turns out it is 2.45. What do you suggest to get the raatio back to about 2.76? a) change the gears in the 904 (with rear pump) b) try to get rid of the rear end...

Which vehicles came with a 7.25 SG? Were 5 on 4.5 axles available? I'm confused, nothing new for a fellow my age.

Everyone says to mill the heads in order to increase the compression, would there be any benefit to milling the block, if you could get it in the milling machine? :-k

I'm going to put discs on the front of my 65 cuda, /6, and keep the drums in the back. Which bolt pattern would be better for selection of rims, would like to go to 15". All opinions and suggestions are appreciated.

A few years ago when I had my /6 rebuilt in my 65 cuda, I had the tranny done also. The shop quoted me for a 904. When I picked the car up ( I didn't really pick the car up, I didn't want to show off) they said it had 2 pumps, 1 in front and another in the rear. Said they should have charged...

Resto-moding my 65 /6 cuda. Contemplating moving the battery to the trunk right side. (enclosed and outside vent battery case). Adding A/C, was delivered in Seattle but now in Ky. Going to improve the audio system, no ground shakers or extreme sound sytems. Other than that will remain stock...

I have a couple of 65 twin post mirrors that are cracked. Is it possible to replace the mirror only, or do I replace the entire assembly? Thanks

Really need right rear wheel opening molding. Will consider a set. Thanks

65 Cuda needing headlight bezels, right rear wheel opening molding, and sill plates, please and thank you ;-)

Ladies and gentlemen, I'm looking for LR wheel opening molding, 2 headlight bezels, and door sills for my 65/6 cuda. Dad bought it new in Seattle. I want to bring back it's glory days and share the car with the folks here in western ky. Thanks for your consideration. Can be reached at...

Need help locating wheel well trim molding, headlight bezels, and door sills for my /6 cuda. Dad bought it new in Seattle. Trying to get it's glory days back. thanks for any assistance