Search results for query: *

port-holio submitted a new Article: How to remove a rusted/frozen radiator hose barb Read more about this article here...

So I bought the hot-****, half-a-mortgage-payment, billet front drum from TCS. http://www.tcsproducts.com/products/product/tf727-steel-front-drum-aluminum-piston/ Now my transmission won't go back together cause the pump body is bottoming out on the drum, even without any thrust washers at...

(SOLD. Thanks Garner22! A+) smallblock pattern 727 with ~3,000 miles since complete performance rebuild - removed from Abody in fine working condition for an overdrive swap. Drove to The Nats and a couple legs of Power Tour without issue. All new bushings, bearings, seals, raybestos...

Had some requests for pics of my friends truck. Eddy ProFlo MPFI intake, big turbo about the size of a 15L diesel turbo, old RV 440 in an ex forestry service truck. Ported smog heads and an old Purple shaft cam. The OEM grill was replaced by an enormous intercooler liberated from some on...

I'm installing the Kiesler kit into a Duster. I followed the instructions for boxing the factory crossmember, but when I tried to put the trans in I'm about 1/2" of interference. Anyone else have this problem? The trans is coming out for the 3rd time to make more room. The boxing was a...

riding shotgun when 440 BB Dodge truck at 12psi WOT blew up last night at the top of third gear. Not a stutter or hickup until it let go with BANG!! followed by a comet tail of sparks, and clang-a-langing. The explosion rocked the truck, flattened the rear right tire, and hit the passenger...

Is the front pinion bearing cone supposed to be a slip fit over the pinion shaft on a 489 case, or does it have to be pressed? I'm setting up a TrueTrac w/ 3.23s, and trying to set pinion depth. The problem is that the front bearing won't go down over the pinion shaft. I've tried this with...

The 913A572 Truetrac won't accept the stock carrier side bearings from my install kit. The TT hubs are a larger diameter (~2.002") than stock (~1.805"). This is the newer Truetrac to fit the stock 30 spline axles. Has anyone experienced this problem too, or found the right part number...

Comp 918 blue stripe beehive springs used with a Hughes hyrdraulic street roller on ported Edelbrock LA RPM heads. Took a little head scratching, but not too tough, since the heads are set up with 2.02"/1.60" Chevy tall race valves from Eddy. I've been meaning to post this for some time and...

I have heard this is possible? I am thinking about using an Eddelbrock ProFlo XT intake (efi tunnel ram), but Eddy only makes it for the Big Block RB mopars.... PH