Search results for query: *

See what size you have and go down from there if I remember they go down in two sizes 60 to 58 to 56 etc. Den

You can leave the carb on the engine to change the jets. Check a few cleaned or new spark plus to see how the change is working.

It's worth finding the cause not only for clean air but THE CAR WILL HAVE MORE POWER WHEN TUNED UP WITH THE CORRECT FUEL MIXTURE. Most guys just throw a carb on the manifold and it runs so they let it go. Spend the time to tune it and you'll like the car a lot more. Den

Pull a few of the plugs out and look at them this may tell the story. Holley carbs are very easy to work on. You can get the jets at about any speed shop. Maybe at Autozone to> Den

High HC readings are from unburned fuel. so look at the following 1.incomplete combustion 2. improper timing 3. ign wires 4. poor compression What was the 02 reading? This will tell you about you fuel mixture. High 02 = lean mixture, vac leaks or ign problems Low 02 = rich...

Where are you guys getting vinyl tops from? Thanks Denny

How much did you end up spending and how much time to get it right? Have you driven the car yet? Thanks Den

I had seen an add that theres a mopar swap meet Sunday the 23rd of April. Location is The root river lanes . 7220 rawson ave, Franklin Wi.

Thanks

Is that the total length? Thanks

Looking for stock a- body axle shaft lengths. Thanks Den

I found this web page that tells about a weak point with the Ford 8.8. Although an easy fix. Den http://www.4x4wire.com/jeep/tech/axle/ford8_8/

Whats the best web site for information about rear axle size,weight etc?

I be watching, I thinking of a Mopar 9 1/4 and cutting it down to size. Any imput froms other is welcome> Den

Hello everyone, I have a 75 Duster with a 6cyl set up but a 440 is waiting in the wings. Which torsion bar whould be the best? The car would be driven on the street and may see the strip once ina while. Thanks Den

Thanks for the photo, I'll need all the parts and there built in the sail panel. Den

I need all the front parts, unforantley unfortunately one of previous owners cut or removed them. Den

I have a 75 Duster with bucket seats and center console that, that needs seat belts. Does anyone know what years the seat belts will inerchange with each other? . Thanks Den

Has any one had any luck or know of nay other rear ends that fit the a-body cars?