Search results for query: *

I am working on a 1972 duster. The car came with the original 340. I am wanting to use a 1966 318 just to keep the car mobile while doing the restoration. I took the motor mounts off of the 340 and put them on the 318 but now there is not enough room for the fan. Everything is to close and...

I am starting a restoration on a 72 Plymouth duster. My question is about quarter panel skins. has any one used a AMD skin? They don't just make the skin any more and the full panels are on back order till the middle of the year, at the soonest. I have found a set of AMD skins. Does anyone know...

I have a 1979 dodge truck. I replaced the brake booster and the master cylinder. When the truck is not running the pedal is hard and seems to have good brakes. When the truck is running the pedal goes to the floor almost. The brakes work but something is wrong. I did bench bleed the master...

I have a dana 70 out of a 1991 dodge dually. Does anyone know if work ok with a granny low transmission. I am trying to get better rpms on the highway, thanks for any help

I have a 1979 dodge truck can the ignition control module be replaced with something else. I am not sure what what all the module does. Thanks

I just finished my old shop truck. Last night while driving with the lights on the truck just died, lost everything lights, radio ect. Then It would not start. I let it sit for 20 minutes then it started. Drove another 10 minutes and it done it again. I looked for a bad ground and could not...

I am new to engine rebuilding. The motors is a 1977 360 out of a RV. The motor had 29k miles on it. The oil looked ok, not milky or gray in color. I left the pistons and rings alone and did not touch the crank. I installed a new cam, lfters and reconditioned heads. New gaskets and new intake...

Does anyone know if 18inch wheels with the bolt pattern 5x115 will work on a 1973 dart with the big bolt pattern? What about fitting over the hub of the disc brakes? Thanks:blob:

Does anyone know if a nv4500 will bolt up to a 1978 360? I am wanting to get rid of the granny low. I have a complete set up from a 1993 gas motor. From the bell housing to the drive shaft. Are the fly wheels the same? Sorry a lot of questions.....