Search results for query: *

Bought a Lokar firewall mount dipstick for the Dart and it appears to be a nice piece. However, according to the instructions you are supposed to put some "automotive silicone" around the base of the tube fitting nut before installing, which I did. The question I have is should this part be snug...

Need some opinions about my Red Holley Electric pump. Ironically enough, on my way to the gas station I ran out of gas (non working gas gauge). The wife brought me a couple of gallons and off to the station. The problem is that now the pump is howling so loud you can hear it above the car...

Need one for a non rally dash. Working of course.

In case any of you were wondering if ol' MacGyver is still alive and well, I can assure you he is alive and well and living in CA! And...unfortunately I bought my car from him! LOL! Some people should not be allowed to own tools. For example, went to change the engine oil for the first time...

Anybody try using Dex 6 in their 727's? I gonna be doing a trans service and I am considering trying it. According to Union 76 application charts it is specified for 70 and up Chrysler Products. It is a synthetic fluid and I am running a stall converter. It should deal with the heat issues...

Need some help with some Cal Custom valve covers on my 440. They use a twist and lock type breather and unfortunately one of them abandoned ship during a test run last Sunday. The one's on the motor now are really cheesy and I would like to get some nice ones. This is the challenge. Anybody have...

If one has a problem with warped header flanges, what would be the best gaskets to use to help seal em up? I put a new set of Fel-pro on and....they didn't work real well. It is going on a 440 with fenderwells.

Does anybody have the bolt that goes in the 8.75 diff that holds the brake hose/line junction, AND is also the breather bolt for the diff? I am in need of one. Thanks Keith

Before they go on fleabay I thought I would give you guys an opportunity to grab these. They are off the A-body 8 3/4 in my Dart. I believe they are for the BBP setup, cause they sure as hell didn't work real good with the SBP setup I currently have. When I measured the gap between the 1 3/4"...

I am trying to redo the rear brakes on my dart and I am quite confused at this point. The shoes are 10x 1-3/4", drums are 10x2". When I pulled it apart the shoes and drums were hashed, with a diagonal wear pattern on the shoes? The shoes do not fit the backing plates and appear to be to small...

The trim pieces that go on the back edge of the driver/pass window, and on the front edge of the 1/4 window on my 69 have a u-channel rubber insert in them that I assume holds them (used to) to the glass. Anybody have any ideas on where to procure replacements or use something to substitute...

I am in need of the left side instrument panel circuit board, only for my 69 Dart. Anybody have one they could spare for a reasonable price? Thanks Keith