Search results for query: *

Thanks, that's what I was looking for, only thing I knew of the build was the 284/484 cam I chose

I cleaned them up, lol, but this engine only has about 3 hrs run time

These are the pistons on my 71 360, motor was done about 20 plus yrs ago, trying to figure out if they are low compression or not, I have no receipts or info since I traded the build for a truck, any help?

Rebuilt short block, new cam and lifters, its not a header leak, it has 0 miles on motor other than in my parking lot and break in

Ok here goes, I think I did a stupid mistake, I got a set of j heads sometime back, I took out the valves and put new ones in, no machining or anything, it has always ticked lick a bad lifter no matter what I do, I have 273 adjustable rockers, i've tried new springs, 2 sets of pushrods, 2 sets...

Do you have a part number on these heads?

bump

Ok, I need pics of tail panel, particularly around the trunk lock area, need to see if there is a peak that goes vertically so all angles would be appreciated

Demon, duster or sport

anyone in the dfw area I can look at tail panel

do you have left fiberglass fender extension?

did you ever find 3445204 i have one but there is not the -5 after part #

I need left side fender extension trim for 71 demon as seen in post # 19

need chrome for 71 demon, hood and fender extension chrome pieces, also drivers side chrome that runs the bottom of rocker panel, oh also need dash pad for 73 dart, thanks

how much for the fender extention and hood chrome pieces, also do u have the drivers side chrome that runs the length of the rocker ?

Did you do anything to the rear suspension? How close are the tires to the springs?

I change mine all the time, this the current one

demon seed, what backspacing and size on the rears and is it stock rear suspension?

screemin demon did you do anything to the suspension or is it stock?

any body not cut the fresh air holes in their hood? I am thinking about not doing this

mating surfaces look good, so i should use cam assembly lube on the new lifters?

oil pressure 80 cold 30 hot, yes i soaked them, i just ordered a set of lunati lifters and called tech line they said not to soak them

cam looks ok, yes i measured for the corrct length, the lifters will not pump up

ok here goes, 71 340 motor with j heads, edelbrock rpm cam, 273 adustable rockers, had engine running but had ticking noise, found 273 pushrods to long, installed new shorter pushrods, noise was still there but not as bad, pulled lifters and they are not any good, ran this engine for about an...

blevedere will not work, taillight is different

dont know if the belvedere is the same or not, ill look into that, but i need upper and lower

I know this isnt the b bodies forum, thought i would check anyway, i'm in need of a right rear quarter panel for a 1965 coronet 2dr or 4dr doesnt matter just need from rear of wheel well back

daves cuda, you have any more pics of the way your wheels and tires fit?

maybe check summit or edelbrock for that lever stud

heres some pics