Search results for query: *

like to put some slotted on. Recommendation where to purchase. I will be installing new bearings, pads, ect..

Have to replace my rotors 69 Barracuda. These old rotors are Century made and both sides are 7/16 x 20 right hand thread studs w/small bolt at 11". Not sure if these hubs are Century or original, being that driver side is now right hand thread studs. Can't locate new rotors with hubs. Do I need...

That's a nice sheild...might have to fabricate some thing. Thx Steve.

Just got my 68 Barracuda brakes completed and the car finally stops. Had to replace the distribution block ( inlinetube ) perfect match. Anyways the brake lines from the master cylinder get hot from the exhaust manifold. I have power brakes and the booster and master cylinder above/side of the...

Yea, that's the one bought. Blk250. Has the piston built inside the block. The tech. team said it works just fine on the 68, even through it's stated 69-74. The other block Blk245 needs a exterior metering/proportioning block.

www.inlinetube.com 586 532-1338 Shipped out of Michigan to Nor-Cal total cost $106.00 UPS ground.

Located the distribution block for A-Body 67-74 at Inlinetube. They manufactor the exact factory replacement BLK250 for disc/drum. No adjustment to brake lines bolt right in. Has anybody tried this block? I have the PL100 GM proprotioning valve that has been used for awhile as a...

Hey, Just bought a proportioning valve from Master Brake. Not the same as the one on my 68 Barracuda. It will work with a few tube bending and fittings and mounting. Lots of work in a tight area. Wanted to know if there is a closer match to the original valve out there. Just thought I would...

Going to start this weekend. Trouble shoot first. Pull the wheels off 1st and go from there. Thanks for the tips

I'll remove the lines and block off. Make sure of the M/C is ok and check to see if the cap continues to seep. I have to remove the line anyways. In a way I hope it is a M/C. The meter block is a little more work.

Just had the master clyinder rebuild. It was a old one off a duster I think. One thing I did notice is that after bleeding the system I pulled the cap off the master cylinder and pumped the brake pedal and a little squirt would come up from the piston on the resivior for the rear brakes every...

I have a 68 Barracuda Formula S with power front disk brakes. The manual states that the safty switch in the metering block displays the red brake light on the dash and that the brake system has a problem. I don't know if this is a proportioning valve or distribution block. Just states a...

I just install the master cyl. to the booster install the lines, filled the reseviors with fluid leaving the cap off and bled the lines starting with the passenger rear, then driver rear, passenger front, driver front. Always adding fluid as needed to complete the bleeding. I had to do this...