Search results for query: *

Thanks again for the help. The relays are installed and working. WOW was I over thinking that project!!

Thanks guys for the help!!! Ok the feedback is normal that is good to know. I will post a pic as soon a I can. The feedback also comes thru the relay, Could I have the wrong relay it should be open until that switch position is selected and no feedback getting thru right?

Trailbeast has been great helping me with this but more info is always good. I decided to install the relays in the wires just behind the switch. I am confident that I am wiring the relays correctly. My car has a 3 speed fan, low comes on when the A/C or heat button is depressed med and high are...

Thanks for the diagram Trailbeast. You drew that for me a couple weeks ago. For some reason I am not seeing how to do this (could be lack of skill??). I would really like to take the load off the switch. they are hard to find and hard to replace. Try to explain it so a 3rd grader can understand LOL.

This is the diagram for my car. I am unclear how to run the power to the relays. The fan comes on low when you push either the A/C or heat buttons. The ignition on power comes to the back of the A/C heat control and splits in to two leads. I believe that one runs the low speed and one runs the...

Ok, Is it common for these switches to melt? I have melted two. Blower motor seems to work fine.

Sorry, yes melt another switch. I was under the impression that this was very common for this to happen.

72 Scamp /6 A/C. I would like to install relays for the blower motor switch so I won't melt another one! I have been staring at the wiring diagram this afternoon and am not seeing how to do this. If someone has done this and could get me going in the right direction I would be grateful. Will I...

Nevermind I got it

I did a search so I wouldn't have to ask this but didn't find what I needed. I need to replace the bulb on the passenger side. I have it almost completely apart but can't figure out how to get the bulb out and don't want to break it. Any suggestions would be great

Never mind

To anyone that has installed one of these does the green tape covering the magnets on the rotor come off or do you leave it on?

Thanks everyone. I thought so but needed to know for sure

That really helps! I am going to an HEI ignition on this slant, already have a coil and pertronics II for it from Greg (Trailbeast). It now has a points distributor so no ECU correct? Been reading lots of posts on the subject. One thing I am unclear of is the voltage regulator. It looks to me...

Could someone give me a lesson on the ignition system in my 72 /6 non electronic. Mainly what does ignition 1 do and what does ignition 2? Thanks

The car does have A/C. I took it out, I don't remember unhooking these but that doesn't mean I didn't!! Thanks

Temp sender also hooked up.

Geez sorry! 1972 Scamp /6. Not horn its hooked up and works. I need to look where they lead to but they are with the wire that goes to AC compressor.

These two connectors are hanging just behind the alt. The car ran and drove without them hooked to anything. Wires are blue/purple. What are they for?

The large red wire in the column plug was in bad shape looks like it got hot at one time. Cut it on both sides of plug and connected it direct, all is good!! Thanks

I did have the column out I will check that today. That sounds like my problem. I will let u know

I dont have signals, radio or dash lights.Is there a way to jumper the neutral safety switch just to see if its the problem?

Keep talking

Thanks grounds have been double checked but I will check again

I spent most of the winter going thru all the systems and detailing under the hood of my 72 Scamp. This included removal of the wiring harness. I was ready to fire her up today but something is not right. I have headlights, horn and dome lights but nothing else? Really new to working on this...

The wiper motor in my 72 Scamp needs to be replaced. When I removed the motor it appears that the previous owner had disconnected it from the wiper arm. The motor has the short arm attached. What kind of clip is used to attach the short arm to the wiper arm and are there any bushings or other...