Search results for query: *

Heres mine:D

Nope

quicksilver mounted and real wood inserts in the console

B&M quicksilver,been beating the hell out of it for years(forward pattern manual shift)

I think you'll be fine because with the green bearings you would remove the buttons in the suregrip carrier.

Thats funny and those guys you talked to should check this out I run a 904 behind my small block I run the low gear pack,forward manual valve body with a 4000 stall converter with a spooled up 4:10 8 3/4 rear. I have had this trans in here for over 4 years without a single issue. I drive it hard...

Did you remove the axle adjusting buttons from the carrier?

Most don't realize it but that is normal. I never knew until I put 275-60-15s on the back of my 69 cuda and its not just our Mopars as my buddies 65 GTO is the same way. Doug

Heres some pics that a few members had asked about with the install of the quick silver shifter in my console.Hope this helps and if I can answer any ???,just ask? Doug

See if this pic shows it better

My B&M quicksilver mounted in the console with real wood trim.