Search results for query: *

I have read somewhere that you can make a driveshaft out of a modified front 4 wheel drive front driveshaft. The one from the transfer case to the front axle.

I believe the carrier cut off is 2:56. any thing above will fit taller gears.

Yessssss! Sorry could not resist.

When you get that 360 in you will love it. I found a BIG difference.

Yup that is the way I have them send stuff. Just ask them.

If you buy from U.S. have it sent USPS no broker fees etc. Ends up a lot cheaper.

Shortened mine 1.6 inches.

No big deal have it shipped to a U.S. parcel service and go get it.

Maybe 8 1/4 or 9 1/4 ?

Sounds like apples and oranges. I would bet with your pushbutton trans. a little silicone sealant and large enough shrink wrap would seal it up nicely.

Thanks checked Randy's website and found 8.25 apprx. $343. or maybe another question would be are these rebuildable and can you swap 27 spline end gears for the 29s ?

I purchased an 8.25 trac-loc unit with 3:55 gears out of a Dakota now the question is will this unit fit my 8.25 out of a 1975 Duster 360 and where can I get 29 spline axels to fit . Thanks Robert.