Search results for query: *

Hey guys. So this is a start up of my newly rebuilt 360. New Cam, pistons, intake, etc. etc. This is a few days after cam break in was completed. Had no problems before. You'll notice some noise right about when I get up close to the engine with the camera. Does anyone have any idea where...

What is a good single spring that would handle about .515" of lift? Lunati recommends a double spring for my new cam, but i'd like to stick with a single spring so I don't have to have my heads machined.

Just wanting some opinions on what direction I should take my 360 build. This will be a 95% street car that I want to be a beast out of the hole, won't see much time past 6000 RPM. As of now the engine is a stock stroke 360, i've got KB 190 pistons, an old speed pro cam that's [email protected]"/304...

Can anyone help me identify this cam?? It was in my 74 360. I couldn't find much info! The stamped numbers are 1177, CS178R, and i THINK GWC. I can't get pics to load but if it would help to see I'll try and get some up.

Just did a compression check on my 360 since I was having problems starting, ALL cylinders were between 55-75. Wet check didn't seem to help much if at all so i'm pretty sure it's not my rings, which are brand new anyway. What would cause EVERY cylinder to have low compression like this? This...

Ok guys... I just got done getting my 360 all put back together. I tore it down to put some higher compression pistons in it about 3 weeks ago. So last weekend I got it all put back together and went to start it and.... nothin. It just cranked and cranked. So I checked fuel at the carb which...

Alright guys quick question... I just ordered some KB 190 pistons (slight dome w/ two reliefs) for my 360. I want to increase the C.R. to about 10:1. These pistons are rated at 10.5:1 with 72cc heads. I am also getting some 596 heads which are advertised right around that 72cc. My question...