Search results for query: *

Getting real close. All mechanicals are done. Fired her up two weeks ago. Runs real nice. Just need to jamb and install the drivers side door and then sand and squirt the outside. Roof is already in black paint so just need to do below. Hung the bumper and set the grille for fitment today...

Been busy working the Demon. Thought I would share some photos. I am doing a two tone with gloss black roof and ev2 hemi orange bottom. Car was originally a vinyl top car so I will be installing the vinyl top trim to the roof to separate the black and orange. Just installed the bulkhead...

wanted to share some of the work. Installed the MSD distributor, wires, control and coil. Hope I mounted them in a good space. The wires are real nice and the boots are very nice. I am making my own wire looms as the valve covers have bolts which will not allow stock looms. I am also using...

Well, we finally slid the stroker under the car. Seems we may get her running this Spring. I seem to have a thing for EV2 Hemi Orange. Mopars are stacked up all over the neighborhood. Can you find them?

Working on the little things now. Intake plugs, brackets, need to figure out a good approach for the wire looms to get fastened to these valve covers. Picked up a nice pair of stock 70 exhaust manifolds to start and break in the cam and then I will be installing my set of Dougs headers once the...

Thought I would share these. Finally got the front end married to the motor. Waiting for bolts to install the tranny and we will be ready to slide her under. Need to get the TTI headers. Also have to get a 4" tall K & N filter to replace the 2" tall one shown. Need more filtration for the...

well, made my choice. My tranny guy is having a unit built which will be in the 2600RPM range for the 416 stroker build. He put a B & M Transpak in the 727 and installed a deep aluminum pan for extra fluid. He also got me a solid flex disc and the converter will have three bearings and...

Having trouble getting the valve covers to sit without hitting the intake. I don't know what the fix is. It is an Edelbrock Air Gap and Mopar valve covers> Any ideas on how to join them without leaks. I have no gaskets under them right now, so I don't know if I should double up the gaskets or...

Got a peek at the stroker. Machine shop just needs to install the roller rockers and pushrods and do a little adjusting and I can take her home.

OK folks, I was actually thinking of doing my Demon EV2 engine compartment in a gloss black to get my engine which I painted orange to POP. I know this goes against the grain on a Mopar but I was curious if anybody else has done this and how it looks? Car will also have a gloss black painted...

Here is the rear end and brakes all done and ready to go back together with the new BBP axels from Dr Diff. Nice stuff. Springs came from Espo, Woodworking equipment will not be installed in the rear of this car.

trying to get a few pictures of my Demon to share