Search results for query: *

When we started the freshly rebuilt 360 the other day, it ran for 5 minutes and got up to 240 degrees. Shut it off at that point. While it was cooling down, I decided to take a look at the oil. It looked like coffee creamer. Drained the oil and removed the filter at that point. Pulled the # 8...

Finishing up building my 360. Went to put in the new dipstick into the block. It`s not going to happen. This is a drag car, so I figure I will just put a plug in the hole where the dipstick goes. The dipstick also hits the windage tray. I don`t want to tap the opening. Any suggestions on what to...

Finishing up 360. Go to place new valve covers on and realize they will need to be notched the same way my old covers were done to fit on my RPM AirGap. Are there any valve covers out there that will not have to be notched using a M1 and J heads?

Can anyone please tell me what these go to. I know they are Mopar and came off a 1972 360. Are the car or truck? Thanks.

I have pulled my factory 318 out of my 71 Dart. Going in will be a 72 360. I am confused as to which motor mounts to use. Any suggestions? Part #`s ? Thanks in advance.

Has anyone grooved the # 2 and 4 cam journals for better oiling on their cam. My buddy doing the machine work wanted me to ask as he mostly builds those other 2 motors.

My son and I are removing the 318 and getting ready to put in the 360. We do not have the means to raise the car and drop everything out from the bottom. My questions is, can we remove the engine and transmission at the same time or will we need to seperate them? The 904 currently attached to...

Trying to decide on a new intake mainfold for my 360 build we just completed. Here`s whats in it: KB191 30 over 12.5 to 1 Comp Cam XE285HL J Heads 1.94 / 1.65 valves 3500 stall Any suggestions?

I am tearing down my 360 so I can send it to be hot tanked. Is there a trick to removing the adapter that holds the oil filter in place?

Winter time is approaching. Time to refresh heads during the winter break. Looking for a good place to buy valves online. Any suggestions.

I picked up a 1972 360 with a 727 this weekend for $50.00. No kidding....$50.00. The motor has been sitting in a garage since 1984. When I started to tear it down today I noticed a few things that made me think the motor had been rebuilt before. One thing in particular. What appeared to be blue...

I am considering purchasing a '78 360 out of a motorhome. It is located about 200 miles from me. The owner is willing to put it on a engine stand and fire it up when I get there. I am planning on rebuilding this motor. Also included is a longshaft 727. All this for $250.00. What do you think...

I pulled to valve covers on the Dart tonight to get the casting number. What I found was #2843675, which is a stock 318 head. My question is, what does the number on the little tag across from the casting number stand for? On the passenger side it was 2293 and the driver side was 11148.

Should I buy it?? 360 cid.72' Dodge Demon motor - $250 (Slo county) Date: 2011-12-02, 8:04PM PST Reply to: [email protected] [Errors when replying to ads?] 360 DODGE LONGBLOCK MOTOR,EARLY CASTING, 1972 DODGE DEMON MOTOR,HAS BEEN SITTING QUITE A LONG TIME AND WILL NEED A...

I am using valve covers similar to these. Problem is the twist on oil breather cap leaks bad. I would like to convert to a push in breather cap. Are there any conversion kits available?