Search results for query: *

Do any of you guys run a 750 cfm carb on a 318 ? The reason I am asking is that I have a holley 600 now. I pulled my heads off a couple weeks ago because I had a bad exhaust valve and low and behold my heads have 1.88 intake valves (675 heads). Had a valve job done and now re tuning. I am now...

I have a holley 1850 that I have a question about. In the picture I am pointing to a screw that sets the closed position of the secondarys. Where should this be set at to start with and if it needs adjustment you have to take the carb off ??. Its going on a 318. Thanks

I pulled off my 1406 to try a holley 1850 on my 318. Anyways I have been tinkering with setting the secondary idle screw ( the one underneath ). The carb to intake gasket is wetter than heck. What would be causing this. . The gasket is gettting soaked from the inside out. Also any good tips for...

Looking for a good answer here. I do know that the 1405 has a manual choke but what else is different. And Why. Luke

So now that I am getting time to drive my car a bit my eddy 1406 is acting up. Today the floats stuck open so I had to pull the top off and clean it out. and it has the typical problem of not wanting to re fire on a hot start. Other than that it seems to work good. Right now I have the thin...

Okay. Is this carter 625 worth saving or not ? came on my car that was sitting for a few years before I got it. Some of you may know from my posts that I swapped the offy intake and this carb for a new performer intake and an eddy 600 carb. Anyways this carb had a big dead spot in it coming off...

This weekend I yanked off my offenhauser intake and old carter 625 and put on a new performer manifold and 1406 carb. Runs great now. Anyways I put about 50 miles on it yesterday on the freeway, through town, and some WOT take offs. When I installed all the new stuff I also Installed new plugs...

Okay so tomorrow I am pulling off the offy intake and carter afb 925sa carb off of my 69 barracuda. All this stuff was put on by the P.O. The car sat for a few years and the gas was beyond gas when I got it but I managed to get it running decent with new fuel. Anyways I got a new edelbrock...