Search results for query: *

Can someone post a photo of the lower end of a floor-shift torque shaft assembly where the lower rod attaches with a rubber grommet?

We tried two different drive shafts and both won't fit the transmission. The 727 output shaft is 1.3" dia. with 30 splines (no master spline). Is this typical for 727 transmissions? The yokes on the test shafts were smaller dia. and had 25 splines with a gap for a master spline. One of the...

Aaron and I just installed Lokar throttle and kickdown cables in his Duster today. The instruction sheet for the kickdown says to adjust it so that when the throttle is wide open the cable has no slack. As I see it, "no slack" in the cable does nothing to pull the throttle pressure lever...

Had to take a hack saw to the rearend U-bolts yesterday to get them off. Where should I look for them at a reasonable price? They are for a Duster 8-1/4" rearend/axle assembly. Thanks, Jerry

Aaron and I finally cracked open the 8-1/4" rearend we planned to swap into his '74 Duster that is under construction. Here is what we found: There wasn't any oil and a couple of bolts inside were loose. Its seems that a previous owner had been doing something in there, but I don't know...

Aaron recently bought a brand new dipstick for his 360, and I thought it a bit odd that the tube was absolutely straight. There's a fuel pump and alternator smack in the way. I figured we would have to bend it to fit, but apparently we bent it too much. Now the dipstick won't hardly slide...

I sure hope we didn't jump ahead of ourselves in our haste to get the transmission and new engine installed in Aaron's Duster. I just realized that, unlike the torque convertor on his Dart Sport's 904, the one we have in his Duster's 727 does not have a drain plug. Of course, that might have...

Saw this in the latest Hemmings Motor News newsletter: Classic Motorsports Group introduces Elite five-speed kits for A-body Mopar Classic Motorsports Group has been eliminating the need for guesswork and fabrication by creating complete kits to merge Tremec gearboxes with classic muscle...

My son is planning on retrieving a 360 V8 from one of his grandparents' extra work vans to swap into his new project, a '74 Gold Duster. What type of automatic transmission would be in a mid-80s Maxi-van, and will it fit in his Duster? Jerry

My son and I are just about ready to test fire his slant six and see if all systems are GO. Then it dawned on me, when we went to Wallyworld to buy all the various and sundry fluids. We took a list of all the fluid capacities from the Haynes manual. Let's see...transmission - 8 qts. Dexron...