Search results for query: *

Has anyone installed a Milodon windage tray with the Milodon stud kit after the block has been lined honed ? The customer I am building a engine for brought the Milodon oil pan, and a windage tray and stud kit. The block has been lined honed and has ARP main cap bolts. I already have the short...

I am building a 372 engine for a 69 Dodge Dart. 340 block, Scat rotating assembly, Trick Flow heads , and the customer just got a Edelbrock RPM Air Gap manifold. The Dart has the stock 340 hood on it, and a RMS Front Suspension. The Air Gap manifold is 1" taller than his old intake, will there...

I am building a 340 for a guy I know, he had the block at the machine shop for over 2 years, and wasn't getting done. It is a 69 Dart street car , with a RMS front suspension and TTI headers. What oil pan might fit ? I should be able to put a rear sump pan on, but not sure about header...

Anyone running a crank turned .040 under on the rod journals? I picked up a 1967 340 short block that was built to race, started and ran a little but never raced. It had a set of W-2 heads on it that leaked. So I got the short block cheap. I was comparing the steel crank to another one I have...

I am assembling a 340 engine and have a M-1 intake laying around I was going to install. Is it worth the time to weld up the spread bore flange to a 4150 style ? Have a 700 Holley carb to use

It has been awhile since I put a stock rebuild together. I got a bunch of parts laying around, so I am putting together a 340. TRW stock replacement pistons, .030 over. Stock rods that were rebushed and honed with new rod bolts. But the holes were not drilled for piston pin oiling. The bushings...

I have a 340 block that is .030. and I have a set of old TRW pistons that are .030 flat top, but I think are about 950 grams each. Any one have their pistons lightened ? Looking to put a cheap street engine together.

Has anyone tried 59 degree cylinder heads on a 48 degree block ? Seems to me there is more 48 degree blocks available, and less 48 degree cylinder heads available. Seen a set of W-9 heads at Carlisle yesterday for a 59 degree block. Seen a R3 48 degree block. Just thinking about a future...

I am wandering what anyone is using for head gaskets on a 340 with the block o-ringed. I purchased a 340 short block that was built in the late 90's, started but never ran much. Had W-2 heads on it that leaked, so a couple cylinders have stains in them. I am going to try to clean it up, check...