Search results for query: *

I've got an old Speed Pro CS181R camshaft for big block, and am looking for specs. I have not had a big block apart lately to pop it into and degree it. Anyone out there have an old catalog?

I put this together last winter for a friend. It was an assembled engine he got with a car. I took it apart, had the assembly balanced and the hone lightly redone. It has speed pro pistons, 8.8 to 1 with a felpro gasket, 2.14, 1.81 valves, I did a little porting in the bowls, Comp Xe268 cam...

Here is an engine I just dynoed. Thought some of you might find it interesting. Put together with mostly used parts I had. 1970 383 with the original cast pistons. Ball honed and new rings. All new bearings. 516 heads I mildly ported and installed used 1.74 exhaust valves. Compression came out...

I did this last winter and I thought some of you may find it interesting. I had a 77 440 highway patrol motor I ran the crap out of in the 90s. Last winter I took it apart to freshen it and swap the cam. I reused the bearings since the crank was reground in 1998 because I spun a rod bearing at...

Can someone tell me where the green and white emissions decal goes on a 72 340 Duster?

Went on a little drive this summer. Beartooth pass. Big rock thing. Beartooth again. Luckily I had 1960's four wheel drum brake technology to slow me down! Alternator blues in Sheridan WY. Nice view.

Not an a-body question, but does anyone know what company might make a new gas tank for a 66 New Yorker/300? Thnaks

Me and my Coronet, good times! YouTube- Albany Chrysler Center Car Show Burn Outs 2010 #10

I am gathering parts for the boss's 70 Challenger. Year one says June before I can get a dash harness. Anyone know of any other places that make Mopar dash harnesses? Or will make a custom one that fits like factory? Thanks

I'm an artist and love Mopars. If anyone wants their car done let me know. Here are a couple examples. These are on 18x24 inch and run about 40 bucks, I can do other sizes too. Thanks Mike