Kendog 170
Let the boy go !
340 Cam Choice
I know there are better cam choices today. I’m not doing this until next spring. I’m staying hydraulic Car is a driver. Want a little more than stock. Something with a little lump but don’t want to over cam it.Hoping to keep springs that came with Eddy I was looking at these two, but I don’t have the knowledge like a lot of you guys and was looking for Input and maybe someone is running close to the same set up and knows a good selection. Car will be mostly for around town but will be taking highway trips as well.
COMP Cams Xtreme Energy Cam and Lifter Kits CL20-223-3
COMP Cams Nostalgia Plus Cam and Lifter Kits CL20-670-4
Here’s what I have
1968 Dodge GTS Convertible 340/4-speed 3200 Lb.
Engine bored .20 over
KB pistons 10.5:1 CR ? 160 PSI cranking compression maybe a little higher?
Eddy RPM heads 60179 (no Porting)
Stock Manifold with Eddy 600 cfm carb. I will eventually go with an Air gap Intake and upgrade to the AVS 2 650 CFM
Stock Cam currently
Stock bottom end (Crank balanced to offset lighter pistons)
Stock Manifolds 2 ¼ Dual Exhaust Flow masters but changing to Walker Quiet-Flow 3 Mufflers
Dodge Electronic Dist./Orange Box
8 3/4 rear 323 Gear Ratio
Front tire size 205/70/14
Rear tire size 235/60/15
I know there are better cam choices today. I’m not doing this until next spring. I’m staying hydraulic Car is a driver. Want a little more than stock. Something with a little lump but don’t want to over cam it.Hoping to keep springs that came with Eddy I was looking at these two, but I don’t have the knowledge like a lot of you guys and was looking for Input and maybe someone is running close to the same set up and knows a good selection. Car will be mostly for around town but will be taking highway trips as well.
COMP Cams Xtreme Energy Cam and Lifter Kits CL20-223-3
COMP Cams Nostalgia Plus Cam and Lifter Kits CL20-670-4
Here’s what I have
1968 Dodge GTS Convertible 340/4-speed 3200 Lb.
Engine bored .20 over
KB pistons 10.5:1 CR ? 160 PSI cranking compression maybe a little higher?
Eddy RPM heads 60179 (no Porting)
Stock Manifold with Eddy 600 cfm carb. I will eventually go with an Air gap Intake and upgrade to the AVS 2 650 CFM
Stock Cam currently
Stock bottom end (Crank balanced to offset lighter pistons)
Stock Manifolds 2 ¼ Dual Exhaust Flow masters but changing to Walker Quiet-Flow 3 Mufflers
Dodge Electronic Dist./Orange Box
8 3/4 rear 323 Gear Ratio
Front tire size 205/70/14
Rear tire size 235/60/15