[WANTED] 1970 rallye dash wiring harness
- Thread starter 44067gtdart
- Start date
-
- Status
A good standard harness can be converted to rally panel harness. This has been covered in a few threads here before. Only 3 wires difference, plus tach wiring if you'll have one.
The 72 model standard harness may be a little more confusing since factory found they could delete one of the switched hot wires to the inst' panel. Still doable.
That other switched hot wire in pre 72 was never fused so the later could be considered better.
The 72 model standard harness may be a little more confusing since factory found they could delete one of the switched hot wires to the inst' panel. Still doable.
That other switched hot wire in pre 72 was never fused so the later could be considered better.
44067gtdart
Well-Known Member
I have a 1971 Dodge Dart Swinger, can that harness be converted? I will look through the old threads and see what I can find. That would definitely be a lot easier if I can convert mine over.
44067gtdart
Well-Known Member
Is this all to it take to convert the harness ? Almost seems too simple.. Will I need to swap sending units or are those all the same ?
yep. Standard with a single circuit board will have a single orange wire for illumination. You'll need to splice another into it since the rally dash has 2 circuit boards requiring orange/illumination to both. Even though one has a oil lamp and other has oil gauge both use the same gray wire, just different types of sender. Replacement oil senders and terminals are available online too.
- Status
-
Similar threads
