[SOLD] 1972 Duster Drag Car ,B1 Engine (Cheap)

-
Status
Not open for further replies.
wupracing

wupracing

Well-Known Member
Joined
Aug 16, 2009
Messages
51
Reaction score
1
Location
Lumberton North Carolina
Rating - 100%
1   0   0
Contact seller
One of the Best Deals on here.
The Motor along cost more than the asking price of the car Turn Key.

Will Sell Running Turn key $10800
Motor ,Trans & Converter $7000
Motor only $6200
Or Rolling with all Eletronics $5000 to sell as Roller Motor must sell first.
Can be bought Race Ready with an 20ft open Trailer for $12800

Lots of NEW Parts
ALL parts listed as NEW has less than 5 runs on them.

This was an Orig. 340 4 speed Duster.

1972 Duster Has a 10 point Roll cage,Tubs,SFI window net,SFI 5 point seat belts,Fiberglass Hood,Trunk and doors.Has Lexan in the doors has the stock Front and Rear glass has a Fiberglass Front Bumper.Optima yellow Battery,5 gal.Fuel Cell,Painless wiring,Auto Meter Gauges & Tach.Dana Rear End with Strange Spool,Strange Axels.
Turbo Action Shifter with
(Brand NEW)3 speed CO2 Biondo Air Shifter
(Brand NEW)Digtal Delay Mega 85 crossover Delay Box
(Brand NEW) MSD 7AL2 Box
Welds super lite wheels with M/T tires 11.5x29.5 (Brand NEW rear Tires with 5 runs)
Mini High Torgue Starter
(Brand New) Magnaflow 500 fuelpump & Filter with a (NEW) Number 10 Braided line from the pump all the way to the (Brand New) Magnaflow Reg.
Has Cal-Trac on the Rear and it Hooks hard.
Has the Shark Tooth Grill

Motor & Trans has around 85 runs them.

Motor is a (400 block) 451ci with B1-BS Heads and a single 1050 Dominator carb.
Ross dome Pistons 14.1
Bill Miller Aluminum Rods
Mopar Stroker Crank
Crane 720 roller with Crane Rockers & Lifters.
Mopar M1 intake
Milodon 7qt. Pan with swing pickup
ATI Super Damper
MSD Billet Distributer
Hooker Super Comp. Headers

Trans is a 727 with a Griner Pro Brake Reverse Pattern
Billet Aluminum Drum
Kevlar Clutches
5500 Stall Converter
SFI Flex Plate
SFI Trans Shield

Car runs 6.30s & high 20s in the 1/8

Last time out it ran a 6.32 at 108 mph with a 1.39 at 60ft. Shifting at 6400 rpm

Motor will run 5.60s to 5.70s in a 2500 lbs car.

OPEN TRAILER
All metal Car Trailer Total lenght is 20ft.It is 81 1/2" wide between fenders.Has a hand crank winch.It has Brand NEW Aluminum Ramps which is 15" wide and 5ft Long.The ramps along cost almost $400 and never been use.






20201624-842-1972-Duster-Drag-car-Mopar-B1-Engine.jpg

20201620-254-1972-Duster-Drag-car-Mopar-B1-Engine.jpg
 
65Vart,

Did not mean to Insult you

I did not say the Best deal on here I said One of them.

But yes The Motor itself would cost you more than the Turn Key Price.
Car is Ready to run and will take it to the track for the buyer.Track is 17 miles away.
 
i dont think you insulted him , i think the wtf is because he wants it & cant have it :)
 
The car belongs to my father and he is 70 years old now and he is not into racing like he use to be because my mother has cancer now and he says he has no time for it..
He Just wants to sell.
Thanks
 
nice car, nice deal. just bought a project car roller. wish i had seen yours first. where are you located? good luck with the sale.
 
Nice looking Duster!!!! Have you raced it over at Benson? I swear i saw that car run at the Benson track.
 
It has been there with a different owner..
My father bought the car and put All New Electronics with Delay box,3 speed Air Shifter,All New Fuel System ,Tires ect.
 
wupracing,
Nice looking car.
It is a great price.
Don't let the dogs get you down,it will sell

Have fun racing.
IMGP2324.jpg


IMGP2328.jpg
 
wupracing said:
65Vart,

Did not mean to Insult you

I did not say the Best deal on here I said One of them.

But yes The Motor itself would cost you more than the Turn Key Price.
Car is Ready to run and will take it to the track for the buyer.Track is 17 miles away.
Click to expand...
Yes I meant I want it and I can't have it. This is a very, very good deal....sorry you mis understood me.
 
Status
Not open for further replies.
-

Back
Top