1st build of 2021 slant six 68 charger beater

[Dart_Doctor]

Well my plan is to beat it up rust it up dirty it up just not too much that it looks like a it's been sitting for 40 years . But you never know if I go to far what will happen lol plan is black on black on black but that also can change

 

[abdywgn]

what kit has the slant six?

 

[MoparMike1974]

forbbodiesmodelsonly.com

 

[diymirage]

hey Asa, you know those tins that pies come in?
or sometimes chinese food too

anyways, those things make great replacement panels
if you cut a section of fender out of that charger and replace it with that pie tin, it will be great to make it look like a damaged panel...right up your alley

 

[Dart_Doctor]

what kit has the slant six?

Limburg dodge 330 ....... and 64 belvedere , I think on more I'm forgetting

 

[Dart_Doctor]

Btw I'm going to have to move back to my unfinished models cuz I cant find the slant 6 and that's the only way I'm building this kit if I dont find it soon I will buy a new kit just for the slanty. Then have a dodge 330 to build also lol

 

[FISHYPETE]

Asa, a slant charger deserves a restoration. LO

 

[abdywgn]

Chrysler Slant 6 Engine, Ross Gibson Engines RGE102

elsewhere, there was also a Hyper-Pac six kit listed by the same company but the page will not come up

I can envision a fleet of dragsters and T-buckets with these engines...

 

[Dart_Doctor]

Asa, a slant charger deserves a restoration. LO

Well we are well beyond that point I just put on the iron oxide lol 1st time using it I hope I got the right **** its supposed to rust later .I did find my slant so i will now keep going

 

[DrillNFill]

Really cool

 

[Dart_Doctor]

Taping and chrome and detailing the slanty.

 

[Dart_Doctor]

Some more odds and ends on the slanty and got the two tone seats and arm rests painted now I need to dirty up both

 

[Dart_Doctor]

Paint fading and interior done

 

[Dart_Doctor]

Some rusting and the door decals. It's going to be my 1st time fading rusting and dirtying decals so wish me luck I'm going to throw some flat clear over them to start.

 

[Kern Dog]

 

[Kern Dog]

 

[Kern Dog]

 

[Kern Dog]

 

[Kern Dog]

 

[Dart_Doctor]

View attachment 1715667266

Ok I quit im not that good lol

 

[Dart_Doctor]

Little more work

 

[Kern Dog]

Ok I quit im not that good lol

I thought it could give you some ideas....IF you needed them.

 

[Dart_Doctor]

I thought it could give you some ideas....IF you needed them.

It dose that thank you

 

[Dart_Doctor]

Slants in and windows in I really glued the slant in most of the time I dont glue my engines in because I may want to rob it for another model lol

 

[krazykuda]

You're doing a nice job Asa... I like your attention to detail...

Don't knock yourself, you are doing a better job than I could do, and I used to build models all the time when I was young....