600 holley linkage

[daniel w. stien]

Does anyone know of a good set up for my throttle linkage? I own a 1975 dodge dart Swinger with a 318. I recently switched carb from a edelbrock (1408) to a 600cm holley. the motor runs good just don't like the way i have the stock linkage set up. throttle cable runs up hill and would like it to pull more straighter. Are there any brackets a person can buy to replace the oem set up. Or any other idea's.

Thanks Dan

 

[RustyRatRod]

What intake do you have? There are a few different brackets on Ebay that Rick Ehrenberg sells that might work for you.

You went downhill with that swap, btw. The Edelbrock is much better. JMO. Wanna sell it?

 

[daniel w. stien]

yes ill sell it. i couldn't get it to idle with out loading up. i put a new kit in it and new floats. floats were set right. i just got sick of messing with it. i was told it was to big a carb for the stock 318 with out rejetting it. (edelbrock intake)

 

[krazykuda]

Just get the adapter bracket and use the stud from the original linkage to attach the cable and kick down to.

Post some pictures of what you have...

 

[daniel w. stien]

not sure how to post a picture, ill post some as soon as i figure out how to post them.

 

[daniel w. stien]

http://www.forabodiesonly.com/mopar/images/attach/jpg.gif

 

[krazykuda]

You need this bracket that bolts to the standard Holley throttle bracket to adapt it for a mopar. Then use the factory "stud" to attach the throttle cable and kick down lever to.

https://www.holley.com/products/fuel_systems/carburetor_components/brackets_and_linkage/parts/20-7


Or look here for brackets and studs:

http://www.manciniracing.com/thleha.html

Note: the replacement studs don't fit as well as the factory originals...