[WANTED] 64-66 Barracuda and Valiant trunk dropoff extensions

[chryslerfat]

Looking for trunk dropoff extensions for my car. Must be Valiant or Barracuda as I was told the Darts are slightly different. Would like price and pics. Thanks

 

[whitepunkonnitro]

I've got a 66 on the chopping block now...could you post a pic of exactly what you're looking for?

 

[chryslerfat]

I will get one tomorrow. Is the 1/4 panels good around the wheels and bottom on the one you are parting?

 

[chryslerfat]

Here are a couple pics of a rusty one.





This is a left but I am looking for both if the price is right.

 

[whitepunkonnitro]

The quarters are very nice around the wheels...There are a couple of minor rust spots but nothing that would not be a quick easy repair. I'm still a little ways from carving on that section of the car yet, but I'll post pics of what I've got later on this evening.

 

[chryslerfat]

Thanks no rush on pics and price. When you get a chance.

 

[chryslerfat]

The quarters are very nice around the wheels...There are a couple of minor rust spots but nothing that would not be a quick easy repair. I'm still a little ways from carving on that section of the car yet, but I'll post pics of what I've got later on this evening.

Any pics?

 

[chryslerfat]

Still looking.

 

[chryslerfat]

Top

 

[2manymopars]

I've got a few dry sets but it would be a while before I could get them out or even pics for that matter.

 

[chryslerfat]

I've got a few dry sets but it would be a while before I could get them out or even pics for that matter.

No problem when you get a chance.

 

[chryslerfat]

Anyone dig up a set yet or either side?

 

[chryslerfat]

Anybody parting one yet?

 

[2manymopars]

I'll have a set ready mid January.

 

[chryslerfat]

I'll have a set ready mid January.

Sounds good I will get this back to the top around then.

 

[2manymopars]

Got the 1/4's cut I will post some pic's when I get the spot welds drilled to expose the inner surface.

 

[chryslerfat]

Got the 1/4's cut I will post some pic's when I get the spot welds drilled to expose the inner surface.

Sounds good. PM sent will wait on pics and price.

 

[2manymopars]

Will email you more.

 

[chryslerfat]

Will email you more.

Looks good PM sent for pics of top and other side.

 

[chryslerfat]

Thanks 2manymopars