64 Barracuda Rocker Molding

[David273cars]

Seems like a simple question...
how do I remove the plastic pins inside the plastic rocker molding clips on my 64 Barracuda?


Thanks
Dave

 

[jysnflem]

drill a small hole in the center of the pin that you can get a sharp screw to start in and use something to pull out. If you push to hard and they go into the rocker panel blow air from the end where the body plugs are and they will fall out the drain slot on the bottom of the rocker panel. I recovered many this way while I was cleaning the media from blasting out of the rocker panels

 

[David273cars]

Thanks!!!!