65 barracuda rear patches

[3404spdfish]

For those who do this. The outer panel fits pretty good, the inner trunk floor extension takes a bit more work.

 

[Beams]

Did you use the goodmark panels? I need to do this eventually…

 

[Plymouth 65]

Nice work, looks great! 65

 

[toolmanmike]

For those who do this. The outer panel fits pretty good, the inner trunk floor extension takes a bit more work.

View attachment 1716508388

Where did you get the panels?

 

[YY1]

Agree.

Whose panels are those?

 

[3404spdfish]

I got the inner and outer for both sides from classic industries. I can post a picture of the inner one when I get back to shop

 

[toolmanmike]

Did you use the goodmark panels? I need to do this eventually…

View attachment 1716508394

66 Dart lower quarter and trunk drop repair

 

[3404spdfish]

The rear of the inner need 3/8 of an inch added to it so cut off the end and make a new piece. Running front to back the inner piece needs a 1/2 inch added to width tapered tho, so again I will cut it off make a filler piece to fit

 

[toolmanmike]

The rear of the inner need 3/8 of an inch added to it so cut off the end and make a new piece. Running front to back the inner piece needs a 1/2 inch added to width tapered tho, so again I will cut it off make a filler piece to fit

View attachment 1716508763

View attachment 1716508764

View attachment 1716508765

Those are the Classic Industries drops? How were they listed in their catalog? You are working on a Barracuda, correct? I am wondering if the Barracuda's are a bit different compared to Valliant's and Darts.

 

[3404spdfish]

First pass I will dye it and sand off tomorrow and see just how bad it is

 

[YY1]

That looks pretty dang good.

Did we get the MFG?

Laysons used to sell one and I thought it was their own design.