66 Dart Brake Light
- Thread starter BenA
- Start date
-
There are sockets with pigtails
These are not listed for 66 but if the diameter is correct...
Add your own wires with the correct connectors to attach to the OEM harness
These are not listed for 66 but if the diameter is correct...
Add your own wires with the correct connectors to attach to the OEM harness
slantsixdan
=..=
The diameter and the focal length (fore-and-aft position of the bulb relative to the reflector) both have to be correct. The reflector is shaped to "look" at a filament in a very specific position. If the focal length is even a small bit off, the reflector can't gather and amplify the light from the bulb, so you'll get a useless little dot of light from the filament viewed through the lens, but not the big, bright, fully-lit lamp area you need to alert the dillweed behind you in the middle of a very important, urgent phone call that it's time to stop.
Absolutely, a wanted thread is where you need to start.
66Dvert
Working on my custom car parts again!
My 66 doesn't have any reflectors (other than the inside of the housing) just the socket to put the light in so find a doorman part number that fits in your hole and protrudes as far as your original one does. I used the pt14 socket for my inner tail light conversion so all 4 of my LEDs light up
Yes, I'm making some replacement Bezels for my crusty worn out ones for my 66.
Yes, I'm making some replacement Bezels for my crusty worn out ones for my 66.
Last edited:
crvtec90
Well-Known Member
Ive got them both sides. I will send you a message
66Dvert
Working on my custom car parts again!
trying to figure out how to clear my in box never mind got it!
Last edited:
Click on the mail icon
Then show all
Select the conversations you want to delete. (Don't worry Al, I did not delete our conversation!)
On the drop-down at the bottom choose an action and press Go
Click on leave conversation.
Select accept or ignore
Click save
Then show all
Select the conversations you want to delete. (Don't worry Al, I did not delete our conversation!)
On the drop-down at the bottom choose an action and press Go
Click on leave conversation.
Select accept or ignore
Click save
Last edited:
slantsixdan
=..=
That is the reflector.
66Dvert
Working on my custom car parts again!
66Dvert
Working on my custom car parts again!
message box is clear now.
-
